TRACK GP 3305413 - Caterpillar

2. Install front section of steering metering pump (11) to its original location in the control group.3. Connect five hose assemblies (12) to their original locations on rear section of steering metering pump (10).4. Install rear section of steering metering pump (10) on the control group. 5. Install bolts (9) that hold front (11) and rear (10) sections of the steering metering pump to the control group. 6. Install cover (6) and bolts (5) to the control group.7. Install cover (8) and bolts (7) to the control group. 8. Line up the mark on steering wheel (2) to the mark on the spline.9. Install steering wheel (2) and nut (4) that holds steering wheel (2) to the control group. Tighten nut (4) to a torque of 48 7 N m (35 5 lb ft). 10. Install spring (3) to its original location in nut (4). 11. Install cover (1) to steering wheel (2).Disassemble Steering Metering Pump
Start By:a. remove steering metering pump 1. Remove housing assembly (1) from pump assembly (2). 2. Remove spiral ring (3) from housing assembly (1). 3. Use Tooling (A) and (B) in order to remove shaft (5) from housing assembly (1).
Housing Assembly (1), Spiral Ring (3), Retainer (4) and Shaft (5)4. Remove retainer (4) from housing assembly (1) after shaft (5) has been removed. 5. Remove spiral ring (6) from shaft (5). 6. Use Tooling (A) and (B) in order to remove bearing (7) from shaft (5). 7. Remove seven bolts (8) and cover (9) from pump assembly (2). 8. Remove spacer (11), gear (12) and gear (13) from pump assembly (2). Remove O-ring seal (10) from gear (13). 9. Remove spacer (14), O-ring seal (15), and drive (16) from pump assembly (2). 10. Remove O-ring seal (20), two springs (19), two anti-cavitation plugs (18) and two balls (17) from pump assembly (2). 11. Remove metering sleeve (22), two races (21) and bearing (23) from pump assembly (2). 12. Remove pin (24) from metering sleeve (22).13. Remove spool (25) from metering sleeve (22).14. Remove spring kit (26) from spool (25). 15. Remove spiral ring (29), bushing (27) and O-ring seal (28) from pump assembly (2). 16. Remove seal (30) and seal (31) from bushing (27). 17. Remove screw (32) from pump assembly (2). 18. Remove seat (34), ball (33) and retainer (35) from pump assembly (2).19. Remove seal (36) and seal (37) from seat (34). 20. Remove two plugs (38) and the O-ring seals from pump assembly (2). 21. Remove two springs (40) and two poppets (39) from pump assembly (2). 22. Remove inlet check valve (41) from pump assembly (2).Assemble Steering Metering Pump
1. Make sure that all of the components of the steering metering pump are clean prior to assembling the pump. During the assembly, check condition of all the O-ring seals that are used in the pump. If any of these seals are damaged, use new parts for replacement. 2. Install inlet check valve (41) in pump assembly (2). The