TRACK GP 3985246 - Caterpillar

Data Status Codes
Table 4
Data Status Identification List    
DSI    Data Status Description    
2     Erratic, Intermittent or Incorrect Data    
3     Voltage High    
4     Voltage Low    
5     Current Below Normal    
6     Current Above Normal    
8     Abnormal Frequency, Pulse Width, or Period    
9     Abnormal Update    
11     Other Failure Mode    
12     Bad Component    
13     Out of Calibration    
16     Parameter Not Available    
17     Module Not Responding    
18     Sensor Power Supply Failure    
19     Incomplete Data or Conditions Not Met    
20     Disabled or Not Installed    Calibration Error ID List
Table 5
Calibration Error ID List    
ID    Calibration Error Description    
$0001     ECM Fault    
$0002     Active Diagnostic Present    
$0003     Another Calibration is Active    
$0004     Calibration Active by Another ECM    
$0005     Loss of Calibration Interlock    
$0006     Calibration Aborted by Tool/Monitor    
$0007     Requested Display Not Supported    
$0008     Unavailable Display    
$0009     Calibration Aborted by ECM    
$000A     Calibration Failure    
$000B     Calibration Not Supported    
$0100     Out-of-Range Low - Incr/Decr Parameter    
$0101     Out-of-Range High - Incr/Decr Parameter    
$0102     Invalid Action/Key Stroke Command    
$0103     Calibration Value Out-of-Range    
$0104     Calibrated Range Too Small    
$0105     Calibrated Range Too Large    
$0106     Calibration Value Not Saved    
$1000     See Service Manual    
$1010     Engine Stopped (No Engine RPM)    
$1011     Engine Running (Engine RPM Present)    
$1012     Engine RPM Incorrect    
$1013     Engine High Idle RPM Too Fast    
$1014     Engine Low Idle RPM Too Slow    
$1015     Abnormal Engine RPM Signal    
$1016     Speed Sensor Circuit is Open    
$1017     Service Brake Pedal Pressed    
$1018     Parking Brake Not Engaged    
$1019     Parking Brake Engaged    
$101A     Implement is Swinging/Traveling    
$101B     Machine Speed Not Zero