TRACK GP 4167045 - Caterpillar

Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Personal injury or death can result from improperly checking for a leak.Always use a board or cardboard when checking for a leak. Escaping air or fluid under pressure, even a pin-hole size leak, can penetrate body tissue causing serious injury, and possible death.If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.
Personal injury or death can result from sudden work tool movement.Sudden movement of the work tool can cause injury to persons near the work tool.To prevent injury or death, make sure that the area around the work tool is clear of personnel and obstructions before operating the work tool.
Parts Section
Table 1
462-1659 Auxiliary Control Arrangement Revision -00
Qty Part Number Description Media
1 336-6358 Chassis Wiring Gp GEHS0266
1 336-6360 Cab Wiring Gp GEHS0179
1 340-2916 Front Lines Gp GEHS0295
1 354-4378 Pressure Sensor Gp GEHS0164
1 372-3923 Valve Ar GEHS0262
1 381-0033 Joystick Control Gp GEHS0329
1 394-5965 Pilot Lines Gp GEHS0878
1 394-5971 Pilot Lines Gp GEHS0879
1 463-2046 Pilot Lines Gp GEHS0874
1 444-9174 Film --
Standard Removal
1 394-5964 Pilot Lines Gp Standard Removal
Illustration 2 g03725157
(A) 394-5964 Pilot Lines Gp
Hose (A) is removed and not used during the installation of this kit.Calibration
Set the machine tool control system.
Reference: Excavator Tool Control System, KENR9698, "Testing and Adjusting Section", "Process for setting Up the Work Tool"Calibrate the machine electronic control system.
Reference: Excavator Tool Control System, KENR9698, "Testing and Adjusting Section", "Work Tool Parameter - Program"Set tool flows and pressures.
Reference: Excavator Tool Control System, KENR9698, "Testing and Adjusting Section", "Process for Setting Up the Work Tool"Reference: Excavator Tool Control System, KENR9698, "Testing and Adjusting Section", "Work Tool - Select"Set the proper operating and/or relief pressures and the proper flows for the tool that is attached to the machine. Refer to the Operation and Maintenance Manual of the specific work tool installed.Principles of Operation
Reference: Excavator Tool Control System, KENR9698, "Systems Operation Section", "General Information"Serial Number Identification 444-9174 Film
Caterpillar Work Tools hydraulic kits are identified with serial numbers. The serial number is printed on a film group (1). This film group should be placed on the right-hand window inside the cab.
Illustration 3 g01742203
(1) 444-9174 Film
Illustration 4 g01743196