TRACK GP 4859784 - Caterpillar

Do not crank the engine for more than 10 seconds. Allow the starter motor to cool for 30 seconds before cranking again.Do not engage the starter when the flywheel is turning.
Release the engine start switch key after the engine starts.Transmission High/Low (14)
Speed Control - This switch controls the speed range of the machine. The machine does not need to be stationary to change the speed range.High Speed Range - Press the top of the switch. (H) Low Speed Range - Press the bottom of the switch. Speeds (1 and 2) are available in low speed range.Creeper Control (15)
Creeper Control - The creeper control allows speed control from a stand still up to full speed. Turn the control clockwise to obtain maximum speed for a given engine rpm. Turn the control counterclockwise to reduce travel speed without reducing engine rpm. The creeper control will only work in speed range 1.Options for Joystick Control
Illustration 12 g03232257
(A) 2 Valve, 1 Handle
(B) 3 Valve, 1 Handle
Illustration 13 g03550490
(C) 4 Valve, 1 Handle
Illustration 14 g03430146
Japan 3 Valve, 2 handle
(27) Joystick Control (28) Speed 1 and Speed 2 (29) Differential Lock (30) Forward/Reverse Control (31) Proportional 3 - Auxiliary Hydraulics (32) Continuous Flow (33) Proportional 4 - Auxiliary HydraulicsFLOAT - Push the lever forward into the detent to activate float. When the lever is moved into the detent, the operator will feel an increased resistance from the lever. Once in the detent position, the lever should be released to the HOLD position to maintain the float function. When the float is activated, the attachment will follow along the contour of the ground. The attachment will remain in the FLOAT position until the lever is moved at least 6 degrees from the HOLD position.LOWER - Push the joystick forward.HOLD - The joystick will return to this position when the joystick is released.RAISE DETENT (If Equipped) - Pull the lever rearward into the detent to activate the Raise Kickout. When the lever is moved into the raise detent, the operator will feel an increased resistance from the lever. Once in the detent, release the lever to the HOLD position to activate the Raise Kickout. The attachment will continue until the attachment reaches the raise kickout height. To override the kickout manually, the lever must be moved at least 6 degrees from the HOLD position.