TRACK ADJUSTER & RECOIL GP 4897197 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Inspect the condition of the gaskets. Replace the gaskets, if necessary.
Illustration 1 g00545514
Typical example
Illustration 2 g00545513
Typical example
Position gaskets (11) and inlet manifold (14) on the cylinder head.Note: Ensure that the front gaskets and the rear gaskets are installed with the notch at the top left side. The center gasket can be installed in either way.
Install bolts (13) that hold inlet manifold (14) on the cylinder head.
Position the turbocharger support on the side of the inlet manifold (14) .
Install bolts (12) that hold the turbocharger support.
Connect boost pressure inlet (10) to inlet manifold (14) .
Install gasket (4) and elbow (2) with four bolts (3) on inlet manifold (14) .
Connect hose assembly (9) to the turbocharger.
Tighten two hose clamps (8) .
Place the bracket for fuel line (6) in position and install two bolts (7) .
Connect fuel line (6) to the air inlet heater.
Connect electrical connector (5) for the air inlet heater, if necessary.