TRACK GP 5341987 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Stud
1/2 inch - 20 by 4 inch 2
B 138-7573 Link Bracket 1
OT-0924 Bolt 1 Start By:
Remove the main hydraulic pump.
Remove the electric starting motor.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g03322183
Illustration 2 g03321560
Remove bolts (4) from Positions (X).
Install Tooling (A) in Positions (X).
Attach Tooling (B) and a suitable lifting device onto flywheel (1). Support weight of flywheel (1). The weight of flywheel (1) is approximately 33 kg (73 lb).
Remove remaining bolts (4).
Use the lifting device to remove the flywheel from the engine.
Illustration 3 g01336669
Typical example
Inspect flywheel (1) and ring gear (5) for wear and damage. Replace any worn components or damaged components.
To remove flywheel ring gear (5), follow Step 7.a through Step 7.b.
Place the flywheel assembly on a suitable support.
Use a hammer and a punch in order to remove ring gear (5) from flywheel (1). Note: Identify the orientation of the teeth on the flywheel ring gear.Installation Procedure
Illustration 4 g01336669
Install ring gear (5) onto flywheel (1).
Illustration 5 g03321560
Illustration 6 g03322183
Using Tooling (B) and a suitable lifting device, install flywheel (1). Install Tooling (A) at Positions (X). Install remaining bolts (4). Tighten bolts (4) to a torque of 120 9 N m (89 7lb ft). End By:
Install electric starting motor.
Install main hydraulic pump.