TRACK GP 5354840 - Caterpillar

Figure 9 - Model of finished installation
Table 10
Item Dimension
Y 10.3 mm
Z Carbon Steel
AA 171 ± 1.5 mm
AB 128 ± 1.5 mm
AC 90 ± 1.5 mm
AD 87.9 mm
AE 22.2 mm
AF 50 ± 1.5 mm
AG Radius 5 ± 1 mm, 90 degree bend
AH 4 nuts 9F-G445 over 10.5mm Æ holes
AJ 69.5 mm
Figure 10 - Fan Mounting Bracket
1. Fabricate bracket (13) above according to dimensions on drawing.
Table 11
Item Dimension
AK 239.5 mm
AL Weld
AM 171.2 mm
Figure 11 - Weld location for bracket
2. Weld bracket to bottom of cab roof as shown.
Table 12
Item Dimension
AT 134.2 ± 1.5 mm
AU 276.5 ± 1.5 mm
AV 96 ± 1.5 mm
Figure 12 - Liner Modification
3. Cut 236-8911 Liner to fit around the bracket. Glue the piece that was removed back in place after welding the bracket in position.
Figure 13 ? Power Wire
4. Install 2L-8076 Terminal (16) and 8T-8729 Pin (15) on 2200 mm wire (17).
Table 13
Item Dimension
AW Voltage Source
Figure 14 ? Power Wire Source
5. Remove rear wiper motor cover. Locate part shown in photo. Remove plug from number 6 hole and insert Pin connected to 7 dm wire.
6. Use Straps 3S-2093 (14) to route wire to the fan.
Table 14
Item Dimension
AX Bracket Bolt
Figure 15 - Fan wiring
7. Bolt Fan (10) to Fan Mounting Bracket using Bolts 4M-5281 (11) and Washers 8T-4205 (12).
8. Check for fan operation. If fan does not operate, remove Bracket Bolt shown in Figure 7. Remove the paint from the two mating bracket surfaces.Reassemble. This will create a better ground.
COPYRIGHT 2004 CATERPILLAR
ALL RIGHTS RESERVED