TRACK GP 5400192 - Caterpillar

Lift brace (72) into place and bolt to the ripper mounting gp (31) using bolt (107), nut (108), and washer (106).
Torque all fasteners to proper specification.
Tighten all hydraulic fittings to specifications. Test cylinders for correct operation and hydraulic leaks.Installation of the Blade Group and Strut Assembly
Table 12
390-1107 Extension Tube Gp    
Item     Qty     Part Number     Description    
(33)     1     390-1107     Extension Tube Gp    
Table 13
Blade Gp    
Item     Qty     Part Number     Description    
(34)     1     275-5875     Blade Gp    
(34)     1     275-5876     Blade Gp    Note: The 275-5875 Blade Gp is used with 390-0349 Snow Blade and Mounting Gp . The 275-5876 Blade Gp is used with 390-0350 Snow Blade and Mounting Gp .
Illustration 25 g02677396
Rear view (11) 331-9951 Bolt
Illustration 26 g02677516
Front view (1) 4B-5327 Washer (12) 299-3401 Hex Slotted Nut (13) 3B-4647 Cotter Pin
Attach the blade group (34) to the mast using bolt (11), and washer (1), nut (12), and cotter pin (13) .
Illustration 27 g02677538
Area (J) with close up.
Attach the vertical link of the link group to the ear assembly on the backside of the blade using the existing hardware.
Illustration 28 g02677639
(33) 275-5881 Extension Tube Gp
Illustration 29 g02950237
(33) 275-5881 Extension Tube Gp (73) 277-3858 Pin As (74) 8S-6377 Lock Pin
Install extension tube (33) to the blade using existing hardware.
Illustration 30 g02950241
Right side view (K) Clevis
Pin the end with the cable attached to the brace using pin as (73), lock pin (74), and existing hardware.
Attach the cable clevis to the brace support group.Note: The cable clevis must be attached to the rear strut support brace group. This cable restricts the travel of the strut group and blade when the shear pin has been sheared.
Illustration 31 g02950245
Bottom view
Torque all fasteners to proper specification. Ensure that the shear-bolt has been fastened with two of 9S-8752 Full Nut .Note: Maintain a supply of 3/8 inch x 4.0 inch grade 8 capscrew, Caterpillar number 8S-9191 Bolt , to use as shear pin. Use only a 3/8 inch diameter grade 8 capscrew as shear pin. Any other type of material or different diameter will not provide the protection required from extreme shock loads. Using any other type of shear pin could result in damage to the snow wing and/or Motor Grader.