TRACK GP 5481199 - Caterpillar

Illustration 1 g06246311
Illustration 2 g06246313
Typical example
Right side view
Table 1
Item Qty Part Specification Description
- All bores must be free of paint. Use 5P-0960 Grease Cartridge in order to coat all the pin bores and the bushings before assembly. After you assemble the bushings coat all the bores and the bushings with 5P-0960 Grease Cartridge.
1 1 248-7820 Pin Diameter is 69.850 0.025 mm (2.7500 0.0010 inch).
2 1 7I-6843 Pin Diameter is 59.850 0.025 mm (2.3563 0.0010 inch).
3 2 517-6026 Pin Diameter is 64.850 0.025 mm (2.5531 0.0010 inch).
4 - - During assembly of the linkage group on the machine, rotate the rod end of the bucket cylinder in order to position the grease fitting away from the stick.
5 1 451-2183 Nut Position the nut (6) to the distance of 0.5 mm (0.02 inch) past the end of the bolt. For locking, tighten the nut (5) against the nut (6).
Torque to 175 30 N m (129 22 lb ft).
6 1 451-2183 Nut
7 4 235-7679 Lip Type Seal Lubricate the sealing lip of the lip type seals lightly with the lubricant that is being sealed. Install the dust seal so that the lip faces the outside, as shown. Install the lip type seals so that the lips of the lip type seals do not extend beyond the face of the boss.
8 2 248-7836 Lip Type Seal Lubricate the sealing lip of the lip type seals lightly with the lubricant that is being sealed. Install the dust seal so that the lip faces the outside, as shown. Install the lip type seals so that the lips of the lip type seals do not extend beyond the face of the boss.
9 2 517-6017 Sleeve Bearing Bore before assembly is 70.17 0.04 mm (2.763 0.002 inch).
Installation depth is 9.73 0.20 mm (0.383 0.008 inch).
10 6 096-4876 Nut Torque to 105 20 N m (77 15 lb ft).
11 2 517-6019 Sleeve Bearing Install the bushing in the bore so that the part number of the bushing is facing outward.
Bore before assembly is 65.129 0.040 mm (2.5641 0.0015 inch).
Installation depth is 9.5 0.8 mm (0.37 0.03 inch).