TRACK GP 5569366 - Caterpillar

Illustration 1 g00103394
(A) Stick cylinder (B) Bucket cylinder (C) Bucket linkage (D) Bucket (E) Boom (1) Torque for two bolts ... 460 60 N m (340 44 lb ft) (2) 107-9852 Pin Assembly Diameter after plating ... 69.85 .025 mm (2.7500 0.0010 inch) Minimum thickness for plating ... 0.005 mm (.0002 inch) Bore diameter for pin ... 70 mm (2.76 inch) (3) Lubricate the sealing lip slightly with the lubricant that is being sealed. (4) 128-9863 Bearing Quantity ... 2 Outside diameter ... 106.20 0.013 mm (4.181 .0005 inch) Inside diameter ... 90.25 0.02 mm (3.553 .001 inch) Install the bearing in the bearing bore. ... 9.5 0.8 mm (.37 .03 inch)Note: Assemble bearings with the groove to the inside of the boss. Assemble bearings with the groove at the rear ( 5°) of the bore. (5) Use the necessary shims to adjust the lateral clearance: Maximum clearance ... 1.0 mm (.04 inch) 133-2424 Shim thickness ... 0.5 mm (.02 inch) 093-0086 Shim thickness ... 1.0 mm (0.04 inch) 093-0118 Shim thickness ... 2.0 mm (.08 inch) (6) 7Y-3551 Bearing Quantity ... 2 Outside diameter ... 85.16 0.013 mm (3.353 .0005 inch) Inside diameter ... 70.23 0.02 mm (2.765 .001 inch) Install the bearing in the bearing bore. ... 7.5 0.8 mm (.30 .03 inch) (7) 128-9882 Bearing Quantity ... 2 Outside diameter ... 106.20 0.013 mm (4.181 .0005 inch) Inside diameter ... 90.27 0.02 mm (3.554 .001 inch) Install the bearing in the bearing bore. ... 9.5 0.8 mm (.37 .03 inch)Note: Assemble bearings with the groove to the inside of the boss. Assemble bearings with the groove at the top ( 5 degrees) of the bore. (8) 4I-4811 Pin Assembly Diameter after plating ... 69.850 .025 mm (2.7500 0.0010 inch) Minimum thickness for plating ... 0.005 mm (.0002 inch) Bore diameter for pin ... 70 mm (2.76 inch)