TRACK GP 6Y4124 - Caterpillar

Removal Procedure
Start By:
Remove the clean gas induction valve. Refer to Disassembly and Assembly, "Clean Gas Induction Valve - Remove".
Sulfuric Acid Burn Hazard, may cause serious personal injury.The turbocharger may contain a small amount of sulfuric acid. The use of fuel with sulfur levels greater than 15 ppm may increase the amount of sulfuric acid formed. The sulfuric acid may spill from the CGI cooler during service of the engine and may travel to other downstream components. The sulfuric acid will burn the eyes, skin, and clothing on contact. Always wear the appropriate personal protective equipment (PPE) that is noted on a material safety data sheet (MSDS) for sulfuric acid. Always follow the directions for first aid that are noted on a material safety data sheet (MSDS) for sulfuric acid.
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01293602
The ends of the bellows are very sharp. Injury could occur if the bellows are not handled properly. Handle the bellows by the convolutions.
Note: Refer to Special Instruction, REHS1728, "Application Guideline for the Bellows" for additional information on handling the bellows.
Disconnect clamp (1) . Disconnect clamp (2) . Disconnect clamp (3) . Remove duct (4) and the bellows.
Illustration 2 g01293555
The ends of the bellows are very sharp. Injury could occur if the bellows are not handled properly. Handle the bellows by the convolutions.
Note: Refer to Special Instruction, REHS1728, "Application Guideline for the Bellows" for additional information on handling the bellows.
Disconnect clamp (5) . Disconnect clamp (6) . Remove duct (9) and the bellows. Disconnect tube assembly (7) . Disconnect tube assembly (7) .
Illustration 3 g01293571
Remove bolt (10) .
Illustration 4 g01293568
Remove nuts (11) .
Use two people in order to remove turbocharger (12) .