TRANSFER GEAR GROUP 2P2946 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g02672140
Slide the locking tab into the unlocked position and disconnect harness assembly (4) from camshaft position sensor (3).
Remove bolt (1). Carefully remove camshaft position sensor (3) from front cover (2). Note: Do not use a lever to remove the camshaft position sensor. Make a note of the orientation of the camshaft position sensor for installation purposes.
Remove O-ring seal (5) from camshaft position sensor (3). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite 506 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g02672140
Install a new O-ring seal (5) to camshaft position sensor (3).
Install camshaft position sensor (3) to front cover (2). Ensure that the camshaft position sensor is correctly orientated.
Apply Tooling (A) onto the threads of bolt (1). Install bolt (1) to the camshaft position sensor. Tighten the bolt to a torque of 10 N m (89 lb in)
Connect harness assembly (4) to camshaft position sensor (3). Slide the locking tab into the locked position.