TRANSFORMER 2736241 - Caterpillar

Product Link PL102C Configuration and Registration
Required Software
Caterpillar Service Tool Software for Product Link PL102C is required in order to configure and in order to register this product.The Caterpillar Service Tool Software for Product Link PL102C is a unique software package for use only with the Product Link PL102C. This software is not related to Caterpillar Electronic Technician.Verify Product Link PL102C System Status
Illustration 1 g01095983
Caterpillar Service Tool Status Tab
Click the "Status" tab in the Caterpillar Service Tool software window.
Use the GPS status group in order to verify the number of satellites that are in view. The module must connect with at least three satellites in order to obtain a position fix.
Verify that the RSSI signal strength is greater than -105. The field that shows the signal strength should register the signal in the "green zone".
Use the "Radio Status" group to verify that there is cellular coverage. A green light for "Microburst" parameters indicates a connection.
With the key in the ON position, verify that the "Power Mode" is in the "Full On" mode. Refer to the "PLM Status Section" for more information.
Verify the status of the key switch. Verify that the key switch is actually in one of the three following positions: On position, Run position and Off position.
Verify if the engine is running. Verify the status of the input for "engine running". Note: There is a 30 second delay in detecting the transition from engine is running to engine is not running.
Verify that the voltage is at the appropriate level. The status bar may not be calibrated if the system voltage configuration parameter has not been set.Configure PL102C Module Property Parameters
Illustration 2 g01096082
Caterpillar Service Tool Configuration Tab
Click the "Configuration" tab.
Go to the "Time Zone" field which is in the "Module Properties" area. Select the time zone in which the machine will be operated.
In the "System Voltage" field, select the system voltage.
In the "DBS Machine Make Code" field, enter the DBS machine make code. Note: The "DBS Dealer Machine Make Code" is a two letter code. An example of the code is AA, which is used for Caterpillar machines. The two letter code is used to indicate the type of machine that the Product Link PL102C module is being installed in. Contact your technical communicator for more details.
Enter the appropriate dealer identification number for the Caterpillar dealership that is installing the unit.
In the "Machine Serial Number" field, enter the serial number of the machine. Note: Only the last eight characters of the machine serial number should be entered into the "Machine Serial Number" field.
If the Product Link PL102C is being installed on a machine that is already in service, then the number of hours that is shown on the machine hour meter should be entered in the "Total Operating Hours" field.Note: If "None" is selected, no data will be provided to Equipment Manager. The reporting period that is chosen will affect the billing costs. Contact your Caterpillar dealer for information about billing rates. Set Reporting Schedule
Go to the "Report Schedule" field. Select