TRANSFORMER AS 3509629 - Caterpillar

Power Train (Transmission Chassis ECM) Software
All M Series 2 Models - Improvement to the inching pedal logic to remove the sequence that could result in a small wheel movement when the inching pedal is depressed and the transmission is shifted to NEUTRAL.All M-Series 2 Models - Improvement to the event activation logic for the E627 (Parking Brake Applied With Machine in Motion) Event. No Event activation when machine travel speed is less than 8 km/h (5 mph) and the parking brake is engaged. A level 2 active only, not logged, event will be activated when machine travel speed is equal to or greater than 8 km/h (5 mph) but less than 16 km/h (10 mph) and the parking brake is engaged. A level 3 active and logged event will be activated when machine travel speed is greater than 16 km/h (10 mph) and the parking brake is engaged.All M-Series 2 Models - Improvement to suppress unnecessary activation of the CID 627, FMI 03 (Parking Brake Pressure Switch, Open/Short to + Battery) diagnostic code for one second from the prior 500 milliseconds when the pressure decreases to below the switch actuation pressure.All M-Series 2 Models - Improvement to suppress unnecessary activation of the CID 127 (Transmission Oil Pressure Sensor) diagnostic code and the CID 96 (Fuel Level Sensor) diagnostic code for 5 seconds after the key start switch is moved to the ON position or the engine is started.12M2, 140M2, 160M2 - Enhancement to the Transmission Output Speed (TOS) control logic to enable improved Autoshift gear shift points under certain machine load conditions.Steering Software (Implement 2 ECM)
All M-Series 2 Models - Improvement to suppress unnecessary activation of the E257 (Steering Output Detected With No Command Given) Event to allow more time for cylinder sensor initialization. Activation of the Event will be suppressed for 5 seconds from the prior one second after the key start switch is moved to the ON position or the engine is started.All M-Series 2 Models - The activation level of the E2085 (Invalid Articulation Response Detected) event has been changed to a Level 2 from the prior Level 1. The new alert level more accurately indicates the severity of the condition to the operator due to the implements having always been locked out when the Event is activated.Implement Software (Implement ECM)
All M-Series 2 Models - Improvement to add a configuration to allow the "Float" function to be disabled for the Auxiliary Hydraulic Valves 1 through 6 on machines that have the attachment. In the auxiliary hydraulic configuration screen, the default status for the valve float function will be "Not Installed". If an auxiliary lever has the float function configured to "Enabled", the programmed valve float configuration will change to "Installed". When the float function is to be enabled for a specific auxiliary valve, the configuration status for the valve must be set to "Installed" and the configuration status for the lever must be set "Enabled". If the configuration status of a valve and the lever