TRANSFORMER 3619097 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
B Loctite 598 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01147783
Apply Tooling (B) to the bottom of front housing (14) at the junction of the cylinder block and the engine oil pan.
Attach a suitable lifting device to front housing (14). The weight of front housing (14) is approximately 70 kg (154 lb). Position the gasket and front housing (14) on the dowel pins on the cylinder block.
Install bolts (16) and bolts (17).
Install bonnet (15).
Trim the gasket between the front housing and the cylinder block even with the bottom of the front housing.
Illustration 2 g01147777
Install bolts (13) and adapters (12).
Illustration 3 g01147762
Connect elbows (11) and bracket (10).
Illustration 4 g01147761
Install engine trunnion (9) and bracket (8).
Illustration 5 g01147758
Illustration 6 g01151441
Install dampers (7) and bolts (6).
Tighten the bolts to a torque of 240 40 N m (177 30 lb ft). Tighten the bolts in the following sequence: 1, 4, 2, 5, 3, 6, 1, 4.
Illustration 7 g01147751
Install engine oil filter (5).
Reposition the filter housing assembly and tighten bolt (4).
Install bolts (3).
Connect harness assembly (2).
Install covers (1).End By:
Install the front engine support. Refer to Disassembly and Assembly, "Engine Trunnion - Remove and Install".
Install the water temperature regulator housing. Refer to Disassembly and Assembly, "Water Temperature Regulator Housing - Remove and Install".
Install the crankshaft front seal. Refer to Disassembly and Assembly, "Crankshaft Front Seal - Install".
Install the water pump. Refer to Disassembly and Assembly, "Water Pump - Install".