TRANSMISSION AR 1803429 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00955826
Typical example
Inspect the fuel injection lines (1) for wear and for damage. Replace any fuel injection line (1) that is worn or any fuel injection line that is damaged.
Loosely install the clamps for the fuel injection lines (1).
Remove the dust caps from the fuel injection pump (3) and from the fuel injectors (2). Remove the dust caps from the fuel injection lines (1).
Loosely connect the nuts at both ends of the fuel injection lines (1).
Ensure that each fuel injection line (1) does not contact any other fuel injection line or any other engine component. Tighten the fasteners for the clamps for the fuel injection lines (1). Check that the fuel injection lines (1) are still clear of other components.
Tighten the fuel injection lines (1) at the fuel injectors (2) to a torque of 30 N m (22 lb ft).
Tighten the fuel injection lines (1) at the fuel injection pump (3) to 30 N m (22 lb ft).
Remove the air from the fuel system. Refer to the Operations and Maintenance Manual, "Fuel System - Prime". End By:
If equipped, install the cover for the fuel injectors. Refer to this Disassembly and Assembly Manual, "Fuel Injector Cover - Remove and Install".