TRANSMISSION AR 1922914 - Caterpillar

Image1.1.1
Step 2 - Remove the window seal or ( see next slide )
Image1.2.1
Step 3 ? Cut the seal adhesive instead to remove it. Independent of the seal actions manner used, the final finish surface of seal should be reconstituted again as per steps 12/13/14 of this instruction.
Image1.3.1
Image1.3.2
Step 4 ? Put the wire of Wire Handle tool into the groove between the polycarbonate and the frame corner of the windshield.
Image1.4.1
Step 5 ? Pull back and forth on each of the handles starting to cut the material in the corner of the polycarbonate.
Image1.5.1
Step 6 ? Lift the polycarbonate corner and Insert the other end of the wire through the hole in the polycarbonate plate.
Image1.6.1
Step 7 - Install another end of the wire into the other handle wire tool.
Image1.7.1
Step 8 ? Start to pull back and forth on each of the handles initiating to cut the adhesive and separate the polycarbonate plate from the steel frame in all window sides.
Image1.8.1
Step 9 ? Remove all residue of adhesive from the window frame surface edge using a knife or scraper.
Image1.9.1
Step 10 - Put a layer of 121-3911 Sika Primer 206 G+P Primer on the polycarbonate plate and over the window frame places where the adhesive will be disposed.
Image1.10.1
Image1.10.2
Step 11 - Put an amount of 175-2935 Sikatack Ultrafast Adhesive in all side of steel window frame.
Image1.11.1
Step 12 ? Install the 296-4188 Polycarbonate plate in the steel window frame. Protect the window seal as indicated to be ready to receive the adhesive.
Image1.12.1
Step 13 ? Put adhesive SIKAFLEX 221 in all seal extension.
Image1.13.1
Step 14 ? Make the surface finish in all extension of the seal.
Image1.14.1
Step 15 - The new polycarbonate plate will be positioned about 6mm out of window frame. Finally reinstall the 139-7101 Window front gp ? in the Cab and remove the plastic covering from the surface of the window.
Image1.15.1