TRANSMISSION & MOUNTING GP 2026008 - Caterpillar

Illustration 1 g02901698
Machine location of auxiliary start receptacle.
Illustration 2 g03394258
(1) Auxiliary start receptacle
(2) Protective cover of auxiliary start receptacle The auxiliary start receptacle is located in a recessed compartment of the right-hand rear bumper.Some Caterpillar products may be equipped with an auxiliary start receptacle. All other machines can be equipped with an auxiliary start receptacle from parts service. Then, a permanent receptacle is always available for jump starting.There are two cable assemblies that can be used to jump start the stalled machine. You can jump start the machine from another machine that is equipped with an auxiliary start receptacle or you can use an auxiliary power pack. Your Caterpillar dealer can provide the correct cable lengths for your application.
Determine the cause of the failure. Use this procedure if the machine does not have a diagnostic connector.
Place the transmission control on the stalled machine in the NEUTRAL position. Engage the parking brake. Lower the implement to the ground. Move all controls to the HOLD position.
On a stalled machine, turn the engine start switch to the OFF position. Turn off the accessories.
On a stalled machine, turn the battery disconnect switch to the ON position.
Move the machine or the auxiliary power source close to the stalled machine so that the cables can reach. DO NOT ALLOW THE MACHINE OR THE AUXILIARY POWER SOURCE TO CONTACT THE STALLED MACHINE.
Stop the engine on the machine that is the electrical source. (If you are using an auxiliary power source, turn off the charging system.)
On the stalled machine, remove protective cover (2) from auxiliary start receptacle (1). Then, connect the appropriate cable to the auxiliary start receptacle.
Connect the other end of this cable to the auxiliary start receptacle of the electrical source.
Start the engine of the machine that is the electrical source. (If you are using an auxiliary power source, energize the charging system on the auxiliary power source.)
Allow the electrical source to charge the batteries for 2 minutes.
Attempt to start the stalled engine. Refer to Operation and Maintenance Manual, "Engine Starting".
Immediately after the stalled engine starts, disconnect the cable from the electrical source.
Disconnect the other end of this cable from the stalled machine.
Conclude with a failure analysis on the starting charging system of the stalled machine, as required. Check the machine when the engine is running and the charging system is in operation.