TRANSMISSION AR 2163950 - Caterpillar

Illustration 7 g00840122
Once you are connected, click over the "Enter Password" (13) in the menu bar.The "Enter User Name/Password" window that is shown in illustration 7 will appear.
Enter "User Name" and "Password".
Click on "OK" button.After the password has been entered, the menu option will change.The menu bar will contain a "Calibrate" option.Note: Make sure that the flywheel vacuum is less than 58 mTorr before the system starts this calibration.
Click on "Calibrate".
Select "AC Currents".You will hear input contactor K1 and output contactor K2 close. The static switch will turn on. The DC Bus voltage will increase. A "Calibration of a Channel" window will open.
Click on "View Status" button.Another "Calibration Group Status" window will open.
Drag the "Calibration Group Status" window aside if the view of "Calibration of a Channel" window is blocked.
Click on "Use Defaults" on "Calibration of a Channel" window.
Illustration 8 g00840916
Note: Add the approximate full load to the system while the system remains in the bypass mode.Note: Make sure that the Bypass Isolation Switch is open.
You will be prompted to "Enter Calibration Point" for "Current in Phase A".Also note that "Maximum" Button on "Calibration of a Channel" window is the default selection.
Illustration 9 g00840945
Clamp the AC current probe around the input conductor for "Phase A" in order to take a reading.
Enter the value from step 25 in the "Enter Calibration Point" field.
Click "OK".The system will process the calibration and the system will prompt you to "Enter Calibration Point for Current in Phase. B" automatically. The "Calibration Group Status" window will display "Calbration Complete but not saved for the current in Phase. A". Refer to illustration 9.
Illustration 10 g00841034
Clamp the AC current probe around the input conductor for "Phase B" in order to take a reading.
Enter the value from step 28 in the "Enter Calibration Point" field.
Click on "OK".The system will process calibration and the system will prompt you to "Enter Calibration Point for Current In Phase C" automatically. The "Calibration Group Status" window will display "Calbration Complete but not saved for the current in Phase. B".
Illustration 11 g00841047
Clamp the AC current probe around the input conductor for "Phase C" in order to take a reading.
Enter the value from step 31 in the "Enter Calibration Point" field.
Click on "OK".The System will process Calibration and the system will prompt you to "Enter Calibration Point for Current out Phase A" automatically. The "Calibration Group Status" window will display "Calibration Complete but not saved for the current in Phase. C".
Illustration 12 g00841119
Clamp the AC current probe around the output conductor for "Phase A" in order to take a reading.
Enter the value from step 34 in the "Enter Calibration Point" field.
Click on "OK".The System will again process Calibration and the system will prompt you to "Enter Calibration Point for Current in Phase B" automatically. The "Calibration Group Status" window will display "Calibration complete but not saved for the current out of Phase A".
Illustration 13 g00841140
Clamp the AC current probe around the output conductor for "Phase B" in order to take a reading.Reference: Refer to Illustration 14.
Enter the value from