TRANSMISSION AR 4214449 - Caterpillar

Table 1
Associated Code
Event Code Description
E198 Low Fuel Pressure Probable Causes
Note: If the engine will not start and Cat ET will not communicate with the ECM, check for the electrical power supply to the ECM. Refer to Troubleshooting, "Electrical Power Supply - Test".Fuel Supply System
Low fuel levelEngine Shutdown Switches (if applicable)
Engine shutdown switchesStarting Aids (if applicable)
Starting aidsRestrictions in the Air Inlet and Exhaust System
Restriction in the air inlet and exhaust systemTheft Deterrent System (if applicable)
Active theft deterrent systemSensors
Coolant temperature sensor
Atmospheric pressure sensor Engine Speed/Timing
Engine speed/timing sensorFuel System
Low-pressure fuel system Recommended Actions
Note: The procedures have been listed in order of probability. Complete the procedures in order.Low Fuel Level
Visually check the fuel level in the fuel tank. Do not rely on the fuel gauge only.
Ensure that the fuel supply valve (if equipped) is in the full OPEN position. Engine Shutdown Switches (if applicable)
The engine shutdown switches must be in the RUN position. Use Cat ET to verify the status of the engine shutdown switches. When a shutdown occurs, the keyswitch must be turned to the OFF position for at least 15 seconds before restarting the engine.Starting Aids (if applicable)
If cold ambient conditions exist, check the operation of the starting aids. Verify that the starting aid is operating correctly. Refer to the appropriate circuit test in order to troubleshoot the starting aid.Restriction in the Air Inlet and Exhaust System
Check for an air filter restriction indicator. Replace plugged air filters. Refer to the Operation and Maintenance Manual for the correct procedure.
Check the air inlet and exhaust system for restrictions and/or leaks. Refer to Systems Operation/Testing and Adjusting, "Air Inlet and Exhaust System" for additional information. Active Theft Deterrent System (if applicable)
Verify that the theft deterrent system is not active.Coolant Temperature Sensor and Atmospheric Pressure Sensor
Use Cat ET to check the output signals of the sensors. The coolant temperature sensor must provide a correct signal in order for cold mode operation to operate correctly. Verify that the coolant temperature on Cat ET is reasonable for the conditions that are present.The atmospheric pressure sensor is used to provide calibrations for the other pressure sensors that are on the engine. Verify that the sensor is reading the correct barometric pressure for the conditions that are present.Engine Speed/Timing
Crank the engine and observe the engine speed on the Cat ET status screen. Refer to Troubleshooting, "Speed/Timing - Test" for additional information.Note: Upon initial cranking, the status for engine speed may indicate that the engine speed signal is abnormal. This message will be replaced with an engine speed once the ECM is able to calculate a speed from the signal.Low Pressure Fuel System
Inspect the fuel system. Refer to Systems Operation/Testing and Adjusting, "Fuel System" for additional information.
Cold weather adversely affects the characteristics of the fuel. Refer to the Operation and Maintenance Manual for information on improving the characteristics of the fuel during cold-weather operation.
Check fuel quality. Check the fuel tank for debris or foreign objects which may block the fuel supply.
Check the filtered fuel pressure while the engine is