TRANSMISSION AR 4235932 - Caterpillar

4235932 TRANSMISSION AR Caterpillar parts 525D

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA4235932
423-5932
4235932

Weight: 1563 pounds 708 kg.

Buy TRANSMISSION AR 4235932 Caterpillar genuine, new aftermarket tractor parts with delivery
WHEEL SKIDDER,

This part in 2 request: Show. This information for suppliers only!

#1483647 4235932

2025-01-15

#1168387 4235932

2023-07-20

Compatible equipment models: 4235932:

WHEEL SKIDDER 525D Caterpillar

Number on catalog scheme:

Caterpillar 4235932 Parts scheme TRANSMISSION AR

For full view, you need register

Information:

Operation Description:The ECM activates the start relay when the key start switch is in the START position and the direction switch is in the NEUTRAL position. The ECM detects a failure in the circuit for the start relay and the electrical system. If CID 0444 or CID 0168 are present the diagnostic code must be corrected before performing the following procedure "Check the key start switch". See Troubleshooting, "Diagnostic Code List".Test Step 1. CHECK THE KEY START SWITCH IN THE START POSITION.
Make sure that a CID 0444 diagnostic code does not exist. If the diagnostic code exists, correct the failure before proceeding.
Disconnect the ECM from the machine harness.
Turn the disconnect switch to the ON position.
Turn and hold the key start switch in the START position.
At the machine harness connector for the ECM, measure the voltage between contact J1-40 (wire 307-OR) and contact J1-2 (ground).Expected Result:The +battery voltage should be present.Results:
YES - The +battery voltage is present. Proceed to Test Step 2.
NO - The +battery voltage is NOT present. The key start switch or the machine harness (wire 307-OR) has failed. Check the key start switch and the machine harness.Repair: If necessary, replace the key start switch and/or the machine harness. Stop.Test Step 2. CHECK THE KEY START SWITCH IN THE OFF POSITION.
The ECM remains disconnected from the machine harness.
Turn the key start switch to the OFF position.
At the machine harness connector for the ECM, measure the voltage between contact J1-40 (wire 307-OR) and contact J1-2 (ground).Expected Result:The +battery voltage should be present.Results:
YES - The +battery voltage is present. The key start switch or the machine harness (wire 307-OR) has failed. Check the key start switch and the machine harness.Repair: If necessary, replace the key start switch and/or the machine harness. Stop.
NO - The +battery voltage is NOT present. The harness circuit operates correctly. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Perform these test steps again. If the cause is not found, replace the ECM. See Testing and Adjusting, "Electronic Control System (ECM) - Replace". Stop.