TRANSMISSION ARRANGEMENT 7S7419 - Caterpillar

Preparing to Start the Engine
Start the engine only from the operator's station. Never short across the starter terminals or across the batteries, as this could bypass the engine neutral-start system as well as damage the electrical system. Inspect the seat belt, the buckle and all mounting hardware. Replace the belt or any damaged hardware. Tighten any loose mounting hardware.Adjust the seat so that full brake pedal travel can be obtained with the operator's back against the seat back. Make certain all protective guards and covers are secured in place.Make sure the machine is equipped with the proper lighting system, as required by conditions. Make sure all lights are working properly.Inspect the machine for potential hazards.Make sure no one is working on, underneath, or close to the machine before starting the engine or beginning to move the machine.Starting the Engine
Do not start the machine or move any of the controls, if there is a warning tag attached to the controls or the starter switch. Shift the transmission control lever to neutral and engage the parking brake before starting the engine. Lower all implements and move all controls to HOLD before starting the engine.Start and run the engine in a well ventilated area only. In an enclosed area, vent the engine exhaust to the outside.Preparing to Operate
Clear all personnel from the machine and the area.Clear all obstacles from the path of the machine. Beware of hazards such as wires and ditches.Make certain all protective guards and covers are secured in place. Clean all windows. Secure the doors and windows in either the open or shut position. Adjust the rear view mirrors for best vision.Make sure the vehicle horn, the backup alarm, and all other warning devices are working properly.Fasten the seat belt securely.Check for proper operation of all controls and protective devices while moving slowly in an open area: Test all controls before starting to work. Be sure that all brakes are operating properly. Test the right and left steering. Check the engine governor control.Operating
Operate the controls only while seated. Operate the controls only with the engine running.Do not allow riders on the machine or on implements unless an additional seat, a seat belt and rollover protection are provided.The operator must satisfy himself that no one will be endangered before moving the machine.Report any needed repairs, noted during operation, immediately.Stay a safe distance from the edge of cliffs, from overhangs, slide areas and from other machines. Carry the bucket close to the ground, approximately 40 cm (15 inches) above ground level.Be careful to avoid tipping when working on hills, banks or slopes, and when crossing ditches, ridges or other obstructions. Work up and down slopes, rather than sideways, whenever possible.If the machine begins to tip forward, lower the bucket quickly to restore balance.If your machine begins to side-slip on a grade, immediately dispose of the load and turn the machine downhill.Reduce the travel speed and use less steering angle to avoid tipping, when working on hills, banks or slopes.Keep the