TRANSMISSION GP 8U5925 - Caterpillar

Removal Procedure
Illustration 1 g02520676
Slide locking tab (5) into the unlocked position. Disconnect harness assembly (6) from harness assembly for temperature sensor (2).
Cut cable straps (3) and cable strap (4) from harness assembly for temperature sensor (2). Note: Ensure that all cable straps are removed for the harness assemblies.
Remove temperature sensor (2) from Diesel Particulate Filter (DPF) (1). Note: Make temporary mark on the temperature sensor to show correct orientation.
Remove the harness assembly for temperature sensor (2) from the bracket on the Clean Emission Module (CEM) Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Bostik Pure Nickel
Anti-Seize Compound 1
Ensure that all components are clean and free from wear and damage. If necessary, replace any components that are worn or damaged.
Illustration 2 g02520676
Lightly lubricate the thread of temperature sensor (2) with Tooling (A). Install temperature sensor (2) to DPF (1). Note: Ensure that the temperature sensor is correctly orientated.
Torque temperature sensors (2) to a torque of 45 N m (33 lb ft).
Position harness assembly for temperature sensors (2) onto the bracket on the CEM.
Install new cable straps (10) and a new cable straps (4) harness assembly for temperature sensors (2). Note: Ensure that cable straps meet the Original Equipment Manufactures (OEM) specification.
Connect harness assembly (6) to harness assembly for temperature sensor (2). Slide locking tab (5) into the locked position.