TRANSMISSION AR 9G7061 - Caterpillar

Illustration 4 g00101446
The oil drain valve is located under the hydraulic tank.
Remove the hydraulic tank access cover that is located under the upper structure. This will allow access to the drain valve.
Illustration 5 g00687273
(4) PlugNote: Refer to Operation and Maintenance Manual, "General Hazard Information" for information that pertains to containing fluid spillage.
Remove plug (4).
Illustration 6 g00687274
(5) Pipe Nipple
(6) Hose
(7) Drain plug
Replace plug (4) with a 3B-7271 Pipe Nipple (5) and hose (6).
Loosen drain plug (7) in order to drain the oil.
Drain the oil into a suitable container.
After the oil has been drained, tighten drain plug (7) to a torque of 110 15 N m (81 11 lb ft).
Remove Pipe Nipple (5) and hose (6).
Clean plug (4) and install the plug. Tighten the plug to a torque of 75 5 N m (55 48 lb ft).
Open the access door on the right side of the machine.
Clean the pump, the hydraulic lines, and the hydraulic tank.
Illustration 7 g01121218
Remove the plug from the tube. Allow the oil to drain into a container.Note: Dispose of used filters and used fluids according to local regulations.
Inspect the O-ring. Replace the O-ring if wear or damage is evident.
Clean the plug. Install the plug and the O-ring into the drain port.
Illustration 8 g01121224
(8) Bolts
(9) Washers
(10) Cover
(11) Spring
(12) Screen
Remove bolts (8), washers (9) and cover (10).Note: Dispose of used filters and used fluids according to local regulations.Note: Do not allow spring (11) to fall back into the tank.
Remove spring (11) and screen (12).Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on containing fluid spillage.
Wash the screen in a clean nonflammable solvent. Allow the screen to dry. Inspect the screen. Replace the screen, if the screen is damaged.
Illustration 9 g00687278
(13) O-ring seal
(14) O-ring seal
Remove O-ring seal (13) from the screen.
Inspect O-ring seals (13) and (14). Replace the O-ring seals if wear or damage is evident.
Install O-ring seal (13) on screen (12).
Install screen (12) and spring (11). Then install cover (10), washers (9), and bolts (8).Note: Make sure that the O-ring seals and the spring are properly positioned during installation.
Fill the hydraulic system oil tank. Refer to Operation and Maintenance Manual, "Capacities (Refill)".
Illustration 10 g01121239
Inspect the O-ring seal on the filler plug for damage. Replace the O-ring, if necessary. Clean the filler plug. Install the filler plug.
Illustration 11 g01121430
(15) Drain hose
(16) Connector
(17) Seal
(18) Negative flow control hoseNote: Make no attempt to start the engine until the pump has been filled with hydraulic oil. Serious damage to the hydraulic components can result.
When the hydraulic oil has been replaced, the air must be removed from the hydraulic oil system. To remove the air from the hydraulic oil system, follow Step 28.a through Step 28.g.
While the engine is stopped, remove drain hose (15), connector (16) and seal (17) from the top of the pump. Add hydraulic oil through the opening.
Check the condition of seal (17). If the seal is damaged, replace the seal.
After the pump has been filled with oil, install drain hose (15), connector (16) and seal (17)