TRANSMISSION OVERHAUL 9S1059 - Caterpillar

Illustration 1 g03291137
Monitor DisplayService the air cleaner daily, or if an event code is displayed on the monitor display.ReferenceRefer to Systems Operation, Troubleshooting, Testing and Adjusting, "Event Code List" for more information.
Service the air cleaner only with the engine stopped. Engine damage could result if the air cleaner is serviced while the engine is running.
This machine uses radial seal type air cleaners. To avoid engine damage, use only radial seal replacement filters. Others will not seal.Radial seal filter gasket design and location are critical to proper air cleaner operation. Use only Caterpillar replacements.
Illustration 2 g02720934
Stop the engine.
Remove cover (1) from the air cleaner housing.
Illustration 3 g02720935
Remove primary filter element (2) from the air cleaner housing.
Clean the inside of the air cleaner housing.
Inspect primary filter element (2). If the pleats, the gaskets, or the seals are damaged, discard the primary element. Replace a damaged primary element with a clean primary element.
If the primary element is not damaged, clean the primary element. The primary element can be cleaned by using the following methods:
Pressure air.
Pressure water.
Detergent washing.When using pressure air, the maximum air pressure is 205 kPa (30 psi). When using pressure water, the maximum water pressure is 280 kPa (40 psi).
Illustration 4 g00905242
When cleaning the inside pleats and the outside pleats, direct the air along the pleats or direct the water along the pleats.The primary element can be washed in a solution that consists of warm water and of nonsudsing household detergent. Fully rinse the pleats. Allow the primary element to air dry completely.
Inspect the primary element after cleaning the primary element. Do not use a primary element if the pleats, the gaskets, or the seals are damaged.
Cover the clean primary element. Store the primary element in a clean, dry location.A primary element may be cleaned for a maximum of six times. Also replace the primary element if the primary element has been in service for 1 year.
Install a clean primary element. Clean and install the cover.Note: Make sure that the primary filter element is properly seated and sealed.Note: If the air filter restriction indicator remains on after starting the engine, or the exhaust smoke is still black, install a new primary filter element. If the indicator remains on after installing a new primary filter element, replace the secondary filter element.ReferenceFor the correct procedure to replace the secondary filter element, refer to the Operation and Maintenance Manual, "Engine Air Filter Secondary Element - Replace" for the machine that is being serviced.