TRANSMITTER AS 5143369 - Caterpillar

1. Unplug the two wires from connector (1) inside analyzer enclosure (3).2. Remove the four nuts at the outside rear of the enclosure, and remove flow analyzer (2) and its mounting bracket from the enclosure. 3. If necessary to remove mounting bracket (4) from analyzer, remove tilt positioning bolt (5). The following steps are for installation of the flow analyzer.4. Align holes of mounting bracket (4) and flow analyzer (2), and install the tilt positioning bolt (5). Position the analyzer face at the desired angle before tightening the bolt.5. Position the mounting bracket studs through the holes at the rear of the enclosure (3) and install the nuts on the outside.6. Plug the two wires back into the connector (1) at the bottom of the enclosure.