TREAD 4679697 - Caterpillar

Illustration 5 g01125209
Use Tooling (A) and rotate the crankshaft until the oil hole of the crankshaft journal is just below the side of the main bearing without the tab. Install Tooling (C) and remove the upper bearing.
The following step is for removing the thrust plates from the cylinder block. Remove the thrust plates on each side of the center main bearing. It may be necessary to move the crankshaft with a prybar in order to remove the thrust bearing from the cylinder block.
Illustration 6 g01125211
Remove lower main bearing (4) from main bearing cap (2). Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 9S-9082 Engine Turning Tool 1
B 9U-5023 Main Bearing Wrench 1
C 2P-5517 Main Bearing Tool 1
D 236-6688 Main Bearing Cap Tool 2
E 9S-7351 Torque Wrench 1
F 8T-5096 Dial Indicator Gp 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Install the main bearings dry when clearance checks are performed. Refer to Disassembly and Assembly, "Bearing Clearance - Check". Apply clean engine oil on the main bearings for final assembly.
Illustration 7 g01125211
Install lower main bearing (4) in main bearing cap (2). Ensure that the main bearing is installed so that the bearing tab fits into the notch in the main bearing cap. Note: The main bearing caps must be installed with the word "FRONT" and the part number toward the front of the engine. Each main bearing cap has a number on the bottom surface and each main bearing must be installed in the corresponding position in the cylinder block.
Install the upper main bearing with the side without the tab into the side of the cylinder block with the tab. Use your hand and roll the upper main bearing into position. Use Tooling (A) and rotate the crankshaft. Rotate the crankshaft until the oil hole is positioned in front of the side of the upper main bearing with the tab.
Illustration 8 g01125209
Install Tooling (C) and finish rolling the upper main bearing into position. Make sure that Tooling (C) does not slide under the upper main bearing. Ensure that the main bearing is installed so that the bearing tab fits into the notch in the cylinder block.
Remove Tooling (C).
The following step is for installing the thrust plates on each side of the center main bearing. Place clean engine oil on the thrust plates. Install the thrust plates on each side of the center main bearing. It may be necessary to move the crankshaft with a prybar in order to install a new thrust bearing. Use Tooling (F) to measure the end play of the crankshaft. The end play must not exceed 0.17 to 0.63 mm (0.007 to 0.025 inch).
Illustration 9 g01125192
Tighten the nuts on Tooling (D) in order to raise main bearing cap (2) to the cylinder block. The nuts must be tightened evenly in order for main bearing cap (2) to fit into the block.
Coat the underside of the bolt heads and the threads of