TROUGH-RH-25FT 2058296 - Caterpillar

Illustration 1 g00546439
Position Tooling (A) under the machine to raise tire and rim (1) off the ground. Position suitable stands under the machine.
Illustration 2 g00583667
If a rear tire is being removed, position Tooling (B) under the machine, as shown.
Illustration 3 g00546440
Remove 59 of the 61 nuts (2) and the washers.
Illustration 4 g00546441
Position a lift truck under tire and rim (1). Use Tooling (C) (not shown) to fasten tire and rim (1) to the lift truck.
Remove the remaining two nuts and washers. Remove the tire and rim. The weight of the tire and rim is 5,260 kg (11,600 lb).
Illustration 5 g00540960
The tire and rim assembly can also be removed by using a tire handler, as shown.Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 1U-9203 Lever Puller 1
B 4C-9814 Reaction Bar 1
4C-9813 Extension 1
4C-9812 Socket 1
6V-6080 Torque Multiplier 1
525-8305 Torque Wrench 1
C 4C-6928 Air/Hydraulic Jack 1
D 1U-9333 Air/Hydraulic Jack 1
Illustration 6 g00546441
Use Tooling (A) (not shown) to fasten tire and rim (1) to the lift truck. Position tire and rim (1) with a lift truck for installation. The weight of the tire and rim is 5,260 kg (11,600 lb).
Illustration 7 g00540960
The tire and rim assembly can also be installed by using a tire handler, as shown.
Illustration 8 g00546440
Install 2 nuts (2) and the washers.
Remove the lift truck or the tire handler.
Install 59 nuts (2) and the washers.
Illustration 9 g00546442
Install Tooling (B) and torque the 61 nuts in an alternating sequence to 1300 200 N m (960 140 lb ft).
Turn the 61 nuts by an additional 90 5° in an alternating sequence.
Illustration 10 g00617162
Illustration 11 g00617163
Use Tooling (C) or Tooling (D) to raise the machine and remove the suitable stands. Lower tire and rim (1) to the ground, and remove Tooling (C) or Tooling (D).End By:
Remove the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chock (Front and Rear) - Remove and Install".
Disconnect the frame lock link. Refer to Disassembly and Assembly, "Frame Lock Link - Separate and Connect".