TRUNNION GP-BULLDOZER 1091352 - Caterpillar

that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, filters, and the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Use mileage, fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, in order to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance.Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant - Change
Coolant Extender (ELC) - Add
Engine Oil Level Gauge - Calibrate
Engine Storage Procedure - Check
Fuel System - Prime
Maintenance Recommendations
Sea Water Strainer - Clean/Inspect
Daily
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Exhaust Piping - Check
Fuel System Primary Filter/Water Separator - Drain
Walk-Around Inspection
Initial 50 Service Hours
Engine Mounts - Inspect
Every 50 Service Hours or Weekly
Aftercooler Condensate Drain Valve - Inspect/Clean
Zinc Rods - Inspect/Replace
Every Year
Coolant Sample (Level 2) - Obtain
Every 14 500 L (3800 US gal) of Fuel or 250 Service Hours or 1 Year
Battery - Clean/Check
Battery Electrolyte Level - Check
Belt - Inspect
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine - Clean
Engine Oil and Filter - Change
Engine Oil Sample - Obtain
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Coolant Sample (Level 1) - Obtain
Every 28 400 L (7500 US gal) of Fuel or 500 Service Hours or 1 Year
Fumes Disposal Filter Element - Replace
Every 57 000 L (15 000 US gal) of Fuel or 1000 Service Hours
Auxiliary Water Pump (Bronze Impeller) - Inspect
Belts - Replace
Engine Valve Lash - Check
Fumes Disposal Filter Element - Replace
Oil Cooler Core - Check/Clean/Test
Every 57 000 L (15 000 US gal) of Fuel or 1000 Service Hours or 2 Years
Aftercooler Core - Clean/Test
Starting Aid (Air Inlet Heater) - Inspect/Clean/Replace
Every 2000 Service Hours
Water Pump - Inspect
Every 114 000 L (30 200 US gal) of Fuel or 2000 Service Hour
Crankshaft Vibration Damper - Inspect
Engine Mounts - Inspect
Engine Speed/Timing Sensor - Clean/Inspect
Heat Exchanger - Inspect
Starting Motor - Inspect
Turbocharger - Inspect
Every 228 000 L (60 300 US gal) of Fuel or 4000 Service Hour
Overhaul (Major)