TUBE 0015274 - Caterpillar

Illustration 2 g01311112
Guidance screen (Linked Elevation Mode) (1) Left Laser Receiver Strike Window (2) Guidance Sensor Icon (3) Right Laser Receiver Strike Window (4) Reference Elevation (5) Elevation Display Icon (6) Device Status IconsA screen that is similar to Illustration 1 is shown when you are in Linked Elevation mode.Independent Elevation Mode
Independent Elevation mode operates with a dual mast system. Independent Elevation mode requires the reference elevation for each mast to be set independently. This means that the blade must be benchmarked under the left and the right mast separately. Refer to Operation and Maintenance Manual, "Setting the Reference Elevation (Dual Mast System)" in order to benchmark the blade in Independent Elevation Mode.
The display shows the two reference elevations that are being worked toward.
Press the left arrow keys in order to move the left mast upward or downward. The elevation offset is applied only to the left side of the blade.
Press the right arrow keys in order to move the right mast upward or downward. The elevation offset is applied only to the right side of the blade.Note: Toggling the remote increment/decrement switch that controls (Elevation Offset) applies the same elevation offset to both masts.
Pressing the "ESC/left reset" key searches for the laser beam and locks on to the laser beam on the left receiver.
Pressing the "OK/right reset" key searches for and locks on to the laser beam on the right receiver.
The "elevation select" key is active in Independent Elevation Mode. This means the following:
Pressing the "Elevation Select" key ensures that both sides of the