TUBE AS 1100286 - Caterpillar

Ether
Read and follow ether manufacture's instruction, when using ether to start a machine.Ether is poisonous and flammable.Breathing ether vapors or repeated contact of ether with skin can cause personal injury.Use ether only in well ventilated areas.Do not smoke while changing ether cylinders.Use ether with care to avoid fires.Do not store replacement ether cylinders in living areas or in the operator's compartment.Do not store ether cylinders in direct sunlight or at temperatures above 39 °C (102 °F).Discard cylinders in a safe place. Do not puncture or burn cylinders.Keep ether cylinders out of the reach of unauthorized personnel.Lines, Tubes and Hoses
Do not bend or strike high pressure lines. Do not install bent or damaged lines, tubes or hoses.Repair any loose or damaged fuel and oil lines, tubes and hoses. Leaks can cause fires. Contact your Caterpillar dealer for repair or replacement.Check lines, tubes and hoses carefully. Do not use your bare hands to check for leaks. Use a board or cardboard to check for leaks. See "Fluid penetration" in the "Safety" section for more details. Tighten all connections to the recommended torque. Replace if any of the following conditions are found:1. End fittings damaged, or leaking.2. Outer covering chafed or cut and wire reinforcing exposed.3. Outer covering ballooning locally.4. Evidence of kinking or crushing of the flexible part of hose.5. Armouring embedded in the outer cover.6. End fittings displaced.Make sure that all clamps, guards and heat shields are installed correctly to prevent vibration, rubbing against other parts and excessive heat during operation.Mounting And Dismounting
Mount and dismount the machine only where steps and/or handholds are provided.Use both hands and face the machine, when mounting and dismounting.Never get on or off a moving machine. Never jump off the machine.Do not try to climb on or off the machine when carrying tools or supplies. Use a hand line to pull equipment up onto the platform.Before Starting The Engine
Start the engine only from the operator's station. Never short across the starter terminals or across the batteries, as this could bypass the engine neutral-start system as well as damage the electrical system.Inspect the condition of the seat belt and mounting hardware. Replace any damaged or worn parts. Replace the seat belt regardless of appearance after three years of use.Adjust the seat so that full pedal travel can be obtained with the operator's back against the seat back.Make sure the machine is equipped with a lighting system as required by conditions. Make sure all lights are working properly.Make sure no one is working on, underneath or close to the machine before starting the engine or beginning to move the machine. Make sure the area is free of personnel.Engine Starting
Do not start the engine or move any of the controls if there is a "DO NOT OPERATE" or similar warning tag attached to the start switch or controls.Move all hydraulic controls to the HOLD position before starting the engine.Start and operate the engine in a well ventilated area only. In an enclosed area, vent the exhaust to