TUBE AS 1105515 - Caterpillar

g01069675
Pressurized system: Hot coolant can cause serious burn. To open cap, stop engine, wait until radiator is cool. Then loosen cap slowly to relieve the pressure.
Battery (5)This warning is located on the LH lower rear part of the hood.
g01069686
Explosion Hazard! Improper jumper cable connections can cause an explosion resulting in serious injury or death. Batteries may be located in separate compartments. Refer to the Operation and Maintenance Manual for the correct jump starting procedure.
Crushing Hazard (6)This warning is located on the rear of the front fender on both sides of the machine.
g01069858
Crushing Hazard. There is no clearance for a person in this area when the machine turns. Severe injury or death from crushing could occur. Connect the steering frame lock between front and rear frames before lifting, transporting, or servicing the machine in the articulation area.Disconnect the steering lock and secure before resuming operation.
Pressurized System (7)This warning is located next to the hydraulic tank filler cap.
g00930639
At operating temperature, the hydraulic tank is hot and under pressure.Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly to relieve pressure.
ROPS/FOPS Structure (8)This warning label is located above the platform on the right side of the cab to the left of the door.
g01211890
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. This will void the certification. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
This machine has been certified to the standards that are listed on the certification plate. The maximum mass of the machine, which includes the operator and the attachments without a payload, should not exceed the mass on the certification plate.Seat Belt (9)This warning is located inside the cab on the RH window.
g01066835
A seat belt should be worn at all times during machine operation to prevent serious injury or death in the event of an accident or machine overturn. Failure to wear a seat belt during machine operation may result in serious injury or death.
No Clearance (10)This warning is located on the rear of the front fender on both sides of the machine.
g00930663
Stay back a safe distance. No clearance for a person in this area when the machine turns. Severe injury or death from crushing could occur.