TUBE AS 1162390 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Stud
M16 - 2 by 4 inch 1
B 138-7573 Link Bracket 1
C FT-2711 Special Bolt 2
D 9S-3263 Thread Lock Compound 1
Illustration 1 g01138041
Remove top bolt (1). Install Tooling (A). Remove remaining bolts (1).
Fasten Tooling (B) and a suitable lifting device to flywheel (2). The weight of flywheel (2) is approximately 40 kg (85 lb). Note: Engines equipped with a Rear Power Take-Off RPTO will need to have Tooling (C) installed. Tooling (C) will hold the RPTO gear tight against the end of the crankshaft during the removal of the flywheel.
Remove flywheel (2).
Use a hammer and a punch in order to remove the flywheel ring gear, if necessary. Installation Procedure
Install flywheel (2) in the reverse order of removal.
Raise the temperature of the flywheel ring gear. Do not use a torch to heat the flywheel ring gear. Install the flywheel ring gear on the flywheel. Position the flywheel ring gear with the part number toward the crankshaft. Allow the flywheel ring gear to cool. Use a soft hammer in order to seat the flywheel ring gear against the shoulder of the flywheel.
Apply Tooling (D) to the threads of bolts (1).
Tighten bolts (1) evenly to a torque of 300 40 N m (221 30 lb ft).
Check the flywheel runout. Refer to Testing and Adjusting, "Flywheel - Inspect".