TUBE AS 1248044 - Caterpillar

Adjustment After Replacement Of Major Components
When major components of the electronic control system have been replaced, adjustment is required.The major components include:* Governor actuator* Proportional reducing valve* Engine speed sensor* ControllerGovernor Actuator
Pump Compartment
(1) Accelerator cable. (2) Connector. (3) Governor actuator. (4) Decelerator cable.
Engine Compartment
(5) Pulley. (6) Inner cable wire (accelerator). (7) Outer cable wire (decelerator).
Installation Of Accelerator And Decelerator Cables
(1) Accelerator cable. (4) Decelerator cable. (5) Pulley. (6) Inner cable wire (accelerator). (7) Outer cable wire (decelerator). (8) Locknut. (9) Nut. (10) Support. (11) Nut. (12) Slot. (13) Locknut.Initial Setting Of Governor Actuator
This procedure is not necessary for a new governor actuator that is correctly calibrated for the initial (factory) dial setting position "10".1. Connect the harness of governor actuator (3) to connector (2).2. Determine the high idle position "10" (initial setting) by activating the automatic actuator calibration mode. See the section in this module "Calibration Mode", Automatic Governor Actuator (G/A) Calibration"Adjustment Of Accelerator Cable
1. Accelerator cable (1) is identified by its seal. Turn nut (11) and locknut (13) of accelerator cable (1) counterclockwise until they are as far apart as possible. If the identification seal is missing, accelerator cable (1) is the upper cable when viewed from the governor actuator (3).2. Place inner cable wire (6) into the inner groove (groove closest to the engine) of pulley (5).3. Wrap inner cable wire (6) around (counterclockwise as viewed from the top of the machine) pulley (5).4. Put the "T" end of inner cable wire (6) into slot (12). Make sure the "T" end of inner cable wire (6) is in line with the inner groove (groove closest to the engine) after installation.5. Put the threaded portion of accelerator cable (1) in the upper notch of support (10).6. Turn pulley (5) clockwise (as viewed from the top of the machine) to the high idle stop position (full rotation position).7. Hold pulley (5) against the high idle stop position and turn nut (11) clockwise until the slack is removed from inner wire (6). Tighten nut (11) approximately an additional two turns by hand.8. Torque (standard torque) locknut (13) against support (10).Adjustment Of Decelerator Cable
1. Turn nut (8) and locknut (9) of decelerator cable (4) counterclockwise until they are as far apart as possible.2. Place outer cable wire (7) into the outer groove (groove farthest from the engine) of pulley (5).3. Wrap outer cable wire (7) around (clockwise as viewed from the top of the machine) pulley (5).4. Put the "T" end of outer cable wire (7) into slot (12). Make certain the "T" end of outer cable wire (7) is in line with outer groove (groove farthest from the engine) after installation.5. Put the threaded portion of decelerator cable (4) in the upper notch of support (10). Make certain outer cable wire (7) remains in outer groove of pulley (5).6. Finger tighten nut (9) against support (10).7. Loosen nut (9) approximately two turns to provide slack in outer cable wire (7).8. Torque (standard torque) locknut (8) against support (10). Make