TUBE AS 1333421 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A FT-1114 Vacuum Cap 1
5P-0306 Vacuum Transducer 1
6V-4142 Fitting 1
5K-5068 Fitting 1 Start By:
Connect the steering frame lock.
Release the hydraulic system pressure.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Illustration 1 g02066920
Install Tooling (A) onto the hydraulic tank . Attach an air supply hose onto Tooling (A). Apply 276 to 414 kPa (40 to 60 psi) of air. This procedure will pull a vacuum on the hydraulic system.
Illustration 2 g02066933
Remove tube assemblies (1). Disconnect hose assembly (3). Disconnect harness assembly (2). Cut cable straps (5) and move harness assembly (2) out of the way. Remove clip (6). Disconnect hose assembly (4) and lay hose assembly (4) out of the way.
Illustration 3 g02066955
Disconnect hose assembly (7) and hose assembly (9). Remove tube assembly (8).
Illustration 4 g02066974
Remove bracket (11) and accumulator charging valve (10) as an assembly.
Illustration 5 g02067053
Remove accumulator charging valve (10) from bracket (11).