TUBE 1425116 - Caterpillar

1. Remove two bolts (2), the washers, and clip (1) from plate assembly (3). Remove eight bolts (4), the washers, four clamps (5), and plate assembly (3) from bracket assembly (6). The following steps are for the installation of the rock guard.2. Make sure all components of the rock guard are clean of dirt and foreign material prior to installation.3. Check all components for wear or damage and replace if necessary. Position the edge of plate assembly (3) 6 2 mm (.24 .08 in) from the back of the moldboard assembly.4. Install plate assembly (3), four clamps (5), eight bolts (4), and the washers to bracket assembly (6). Install clip (1), two bolts (2), and the washers to plate assembly (3).