TUBE AS 1427765 - Caterpillar

Illustration 1 g01293806Remove frame lock pin (1) after pulling back on spring rod (2). Store the frame lock pin in storage bracket (3). Frame lock pin (1) must be removed in order to articulate the machine. Refer to Operation and Maintenance Manual, "Steering Frame Lock" for more information.
Illustration 2 g01153708
Do not operate the machine with the wheel lean bolt in the locked position. Machine damage may occur.
Remove wheel lean locking bolt (4) from the locked position.Start the engine only from the operator's compartment. Never short across the starter terminals or across the batteries. Shorting could bypass the engine neutral start system. Shorting could also damage the electrical system.
Illustration 3 g01323177Depress horn button (5) in order to make sure that the machine horn works properly.
Illustration 4 g01955418The mirrors on your machine may be different. Adjust the mirrors for the best operator vision. Adjust the inside mirror or the inside mirrors before you operate the machine. If the machine is equipped with outside mirrors, adjust the outside mirrors before you operate the machine. Refer to Operation and Maintenance Manual, "Mirror" for more information on the mirror adjustment.Inspect the condition of the seat belt and the condition of mounting hardware. Replace any damaged parts and any worn parts. Regardless of appearance, replace the seat belt after three years of use. Do not use a seat belt extension on a retractable seat belt.Adjust the seat in order to achieve full pedal travel when the operator's back is against the back of the seat.Adjust the seat in order to achieve good posture.Adjust the control pod height and adjust the control pod fore/aft position. Your elbow should be slightly ahead of your shoulder. Your wrist should be slightly below your elbow.Make sure that the machine is equipped with a lighting system that is adequate for the job conditions. Make sure that all lights are working properly.Before you start the engine or before you move the machine, make sure that no one is on the machine, underneath the machine, or around the machine. Make sure that there are no personnel in the area.