TUBE AS 1473785 - Caterpillar

Illustration 1 g02023586
Schematic for the Raise Solenoid
This diagnostic code is associated with the raise solenoid valve. The FMI 03 means that the ECM has determined that the voltage of the solenoid circuit is above normal.Ensure that the diagnostic code of CID 0354 FMI 03 is active before performing this procedure.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. The possible causes of this diagnostic code are listed:
The energize circuit of the solenoid is shorted to the +battery circuit.
The ECM has generated this code in error.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The machine response is listed:All implement functions will be disabled.Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO THE +BATTERY CIRCUIT.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connectors from the solenoid and the ECM.
At the machine harness connector for the ECM, measure the resistance from contact J1-48 (wire H713-PK(Pink)) to all contacts that are used in the machine harness connectors for the ECM. Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 2.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J1-48 (wire H713-PK(Pink)) and the circuit that has a low resistance measurement.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. Check The Harness And Connectors
Disconnect the machine harness connectors from the solenoid and the ECM.
Inspect the contacts and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Determine if the CID 0354 FMI 03 diagnostic code is active. Expected Result:The CID 0354 FMI 03 diagnostic code is active.Results:
YES - The CID 0354 FMI 03 diagnostic code is active. The problem has not been corrected. The ECM may have generated this diagnostic code in error.Repair: Exit this procedure and perform this procedure again. If the cause of the diagnostic code is not found, the ECM may need to be replaced. Prior to replacing an ECM, always contact your dealership for possible consultation with Caterpillar. This consultation may greatly reduce repair time. If the ECM requires replacement refer to Testing and Adjusting, "Electronic Control Module (ECM) - Replace".STOP
NO - The CID 0354 FMI 03 diagnostic code is not active. The problem does not exist at this time.Repair: The initial diagnostic code was probably caused by a poor electrical connection or a short at one of the harness connectors that was disconnected and reconnected. Resume normal machine operation.STOP