TUBE AS 1612442 - Caterpillar

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Illustration 6 g02091596
Illustration 7 g01964860
Typical example
If necessary, follow Step 1.a through Step 1.d in order to install gear (18) to the air compressor.
Ensure that the shaft of air compressor (6) is clean, free from damage, and dry. Ensure that gear (18) is clean and free from damage and dry.
Install gear (18) and a new spring washer (19) to the shaft of the air compressor.
Apply Tooling (D) to the threads of the shaft. Install nut (20) to the shaft of air compressor (6).
Use a suitable tool in order to prevent the shaft of the compressor from rotating. Tighten nut (20) to a torque of 120 N m (89 lb ft).
If necessary, install hose assembly (23) to the connection on the cylinder block. Align hose assembly with the temporary marks. Tighten nut (22) to a torque of 9 N m (80 lb in).
Use Tooling (E) in order to lubricate a new O-ring seal (21). Install the O-ring seal to air compressor (6).
Use Tooling (A) in order to rotate the crankshaft so that number one piston is at the top center position on the compression stroke. Refer to Systems Operation, Testing and Adjusting, "Finding Top Center Position for No.1 Piston" for the correct procedure. Note: The air compressor must be timed with the engine in order to minimize engine vibration.
Illustration 8 g02021419
Ensure that Tooling (B) is installed in Hole (X) in the cylinder block. Use Tooling (B) in order to lock the crankshaft in the correct position. Note: Do not use excessive force to install Tooling (B). Do not use Tooling (B) to hold the crankshaft during repairs.
Illustration 9 g02358916
Typical example
Illustration 10 g01965121
Typical example
Rotate the crankshaft of the air compressor until timing Mark (Y) is aligned with timing Mark (Z) on the rear face of the air compressor.
If necessary, install studs (14) to the front housing. Tighten the studs to a torque of 25 N m (221 lb in).
Align air compressor (6) with studs (14). Install the air compressor to the front housing. If necessary, rotate the crankshaft of the air compressor in order to allow the gears to align.
Install nuts (15). Tighten the nuts to a torque of 78 N m (58 lb ft).
If necessary, follow Step 10.a through Step 10.c in order to install cover (16).
Use Tooling (E) in order to lubricate a new O-ring seal (13). Install the O-ring seal to cover (16).
Install plate (16) to the air compressor.
Install bolts (17). Tighten the bolts to a torque of 16 N m (142 lb in).
Illustration 11 g01964836
Position support bracket (11) onto air compressor (6). Install bolts (10) finger tight.
Install bolts (12) finger tight.
Tighten bolts (10) to a torque of 22 N m (195 lb in).
Tighten bolts (12) to a torque 44 N m (32 lb ft).