TUBE AS 1765690 - Caterpillar

Failure to properly service the batteries may cause peronal injury.Prevent sparks near the batteries. They could cause vapors to explode. Do not allow the jump start cable ends to contact each other or the machine.Do not smoke when checking battery electrolyte levels.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.Always wear eye protection when starting a machine with jump start cables.Improper jump start procedures can cause an explosion resulting in personal injury.Always connect the battery positive (+) to battery positive (+) and the battery negative (-) to battery negative (-).Jump start only with an energy source with the same voltage as the stalled machine.Turn off all lights and accessories on the stalled machine. Otherwise, they will operate when the energy source is connected.
To prevent damage to engine bearings and to electrical circuits when you jump start a machine, do not allow the stalled machine to touch the machine that is used as the electrical source.Turn on (close) the battery disconnect switch prior to the boost connection to prevent damage to electrical components on the stalled machine.Use only equal voltage for starting. Check the battery and starter voltage rating of your machine. Use only the same voltage for jump starting. Use of a welder or higher voltage will damage the electrical system.Severely discharged maintenance free batteries do not fully recharge from the alternator after jump starting. The batteries must be charged to proper voltage with a battery charger. Many batteries thought to be unusable are still rechargeable.Refer to Special Instruction, SEHS7633, "Battery Test Procedure" for complete testing and charging information. This publication is available from your Caterpillar dealer.
When the auxiliary starting receptacles are not available, use the following procedure.
Determine the reason that the engine will not start. Refer to Special Instruction, SEHS7768 for information on the 6V-2150 Starting/Charging Analyzer. This is still a valid procedure if the machine does not have a diagnostic connector.
Lower the equipment to the ground. Move all controls to the HOLD position. Move the lever for the hydraulic lockout control to the LOCKED position.
Turn the start switch on the stalled machine to the OFF position. Turn off all accessories.
Turn the battery disconnect switch on the stalled machine to the ON position.
Move the machine that is being used as an electrical source near the stalled machine so that the jump start cables reach the stalled machine. Do not allow the machines to contact each other.
Stop the engine of the machine that is being used as an electrical source. If you are using an auxiliary power source, turn off the charging system.
Ensure that battery caps on both machines are tight and correctly placed. Ensure that batteries in the stalled machine are not frozen. Make sure that the batteries have enough electrolyte.Note: The positive terminal and the negative terminal of the 24 volt systems must be identified correctly before the jumper cables are connected.
The positive ends of the jump start cable are red. Connect one positive end of the jump start cable