TUBE 1992569 - Caterpillar

27. Remove dowel (39).28. Remove seat (40). 29. Remove the sleeve from seat (40). Remove retainer ring (41) from sleeve (43). Remove races and bearing (42) from the sleeve.30. Remove washers (46) and spring (44) from seat (40).31. Remove bolt (45) from the seat. 32. Remove lockring (48) from weight assembly (49). Remove the weight assembly cylinder (47).33. Remove piston assembly (50) from cylinder (47). 34. Remove sleeve (52) from the piston assembly. Remove O-ring seal (51) from the sleeve. 35. Remove ring (53). Remove pinion (54). 36. Remove ring (55) from retainer (59). Remove the dowel. Remove gear (56). 37. Remove yoke (57) and springs (58) from gear (56). 38. Remove bolt (60) and the lock. Remove cover (61). 39. Remove gear (62). Remove shaft (64) and gear (63) from the housing. Use a press to remove the gear from the shaft. 40. Remove bearing (65) from the housing. 41. Remove valve assembly (66) from the housing. Remove pin (67). Remove the piston and the spring from the valve body.Assemble Governor (Later)
1. Clean and inspect all parts. Make a replacement of all parts that are worn or damaged. Put clean engine oil on the O-ring seals.2. Put the spring and the piston in position in the valve body. Install the pin. The pin must not extend beyond the sides of the valve body. Install the gasket and the valve assembly in the housing. Tighten the valve assembly to a torque of 50 10 lb.ft. (70 14 N m). 3. Use a press and tooling (A) to install bearing (1) in the housing. The top of bearing (1) must be .470 .005 in. (11.94 0.13 mm) above surface (X) of the housing. 4. Install gear (2) on the bearing.5. Use a press to install gear (3) on the shaft. Install the shaft and gear in the housing. 6. Put cover (4) in position. Install the lock and bolt to hold it in position. 7. Use pins to install yoke (5) and gear (7) on springs (6).8. Put the gear assembly in position in shaft (8). Put a dowel through the holes in retainer (9), shaft (8) and gear (7). Install the retainer ring to hold the dowel in position. 9. Install pinion (10). Install the ring (not shown) to hold the pinion in position. 10. Install O-ring seal (11) on the sleeve.11. Install the sleeve on piston (12).12. Install the piston in cylinder (13). 13. Install valve (15) in the piston.14. Install cylinder (13) in weight assembly (16). Install lockring (14) to hold the weight assembly in position. 15. Install races (18) and bearing (17) on sleeve (22). Install retainer ring (21) on the sleeve to hold the bearing and the races in position.16. Put bolt (24), washer (23), spring (19), washer (23) and sleeve (22) in position in seat (20).17. Put seat (20) in position on the weight assembly. 18. Make sure the holes in valve (15), the sleeve and seat (20) are