TUBE AS 1W5588 - Caterpillar

Illustration 1 g03796793
Schematic of the Pattern Change Switch
This diagnostic code is associated with the Pattern Change Switch. This diagnostic code is recorded when the status of both the normally open inputs and the normally closed input are grounded. This switch has three inputs to the ECM. Two inputs are normally open and one is normally closed. During proper operation in one held switch position, one normally open contact will be closed and the other normally open contact will remain open. When the switch is actuated to the opposite position, the first contact will be open and the other normally open contact will be closed.The possible causes of this diagnostic code are listed:
A normally open circuit is shorted to ground while the normally closed circuit is grounded through the switch.
The normally closed circuit is shorted to ground while the normally open circuit is grounded through the switch.
The normally open circuits and the normally closed circuits are shorted to ground in the harness.
The normally open circuits and normally closed circuits are shorted together. The switch must be in one specific position.
The switch has failed.System Response:If the switch is faulted during operation, the last known value will be saved. If the switch is faulted at power up, the park brake will remain engaged and the implements will be locked out.Table 1 contains wire numbers and connector contacts. Use this information to troubleshoot the failed circuit.
Table 1
Switch Continuity
Switch / CID Switch State Machine ECM Connector Contact No. Switch Contact Wire No. Status
CID 1007 Pattern Change Switch Not Actuated J2-57 N/O(1) N/O J753-BU(Blue) O(2)
J2-58 N/C(3) N/C P797-GN(Green) G(4)
J2-61 N/O N/O P796-OR(Orange) O
Actuated to "H" Position/#2 Alternate Pattern J2-57 N/O N/O J753-BU(Blue) G
J2-58 N/C N/C P797-GN(Green) O
J2-61 N/O N/O P796-OR(Orange) O
Actuated to "#1 Cat/ISO" Position J2-57 N/O N/O J753-BU(Blue) O
J2-58 N/C N/C P797-GN(Green) O
J2-61 N/O N/O P796-OR(Orange) G
(1) N/O = Normally Open.
(2) O = Open (no continuity to ground).
(3) N/C = Normally Closed.
(4) G = Grounded (continuity to ground).Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code is corrected.Ensure that the diagnostic code is active. Test Step 1. Check The Switch
Observe ON/OFF status of the diagnostic code indicator.
Disconnect the connector of the switch from the harness. Expected Result:The diagnostic code remains active.Results:
YES - The diagnostic code remains active. The switch is not the cause of the diagnostic code. Proceed to test step 2 .
NO - The diagnostic code is inactive. The switch has failed or the harness has failed.Repair: Repeat this test in order to verify the failure of the switch. Repair the switch or replace the switch. Repair the harness or replace the harness.STOPTest Step 2. Check The Harness Circuit
This test checks the continuity of the entire harness circuit that has failed. This test includes the switch that was previously checked.
Reconnect the switch that was disconnected in the previous step.
Disconnect the harness from the ECM.
Activate the switch in one direction. At the harness connector for the ECM, check the continuity to ground