TUBE AS 2070445 - Caterpillar

With the engine running, this machine spot turns when the steering wheel is turned, even with the transmission in NEUTRAL and the parking brake engaged.To avoid personal injury due to unexpected machine movement, make sure the area is free of personnel before starting the engine.Be prepared to apply the service brakes to counteract any steering that might occur when the engine starts.
Use the following procedure in order to start the engine when the ambient temperature is 0°C (32°F). Also, use this procedure for engines that are at operating temperature or near operating temperature when the temperature is below 0°C (32°F).
Never push or tow the machine to start the engine. Doing so may damage the drive train.
Illustration 1 g00398978
Adjust the fore/aft seat movement isolator in order to allow full operation of the inching clutch pedal and of the service brake pedal. Note: If you use the fore/aft isolation, make sure that the pedals can be fully applied from the farthest rearward position. Do not move the seat too close to the dash panel. This could impede access to the operator's compartment.
Illustration 2 g00398983
Move the transmission control lever to the NEUTRAL position.Note: A safety device prevents the starter motor from operating unless the transmission control lever is in the NEUTRAL position.
Illustration 3 g00623209
Engage the parking brake.
Illustration 4 g00399018
Move the implement control levers to the HOLD position.
Illustration 5 g00399038
Move the governor control lever to the LOW IDLE position.
Illustration 6 g00391137
Fully depress the inching clutch pedal.
Briefly sound the horn in order to alert bystanders.
Illustration 7 g00399043
Turn the engine start switch key to the START position. Release the key when the engine starts.