TUBE AS 2099559 - Caterpillar

Note: Ensure that the mounting surface is clean and free of grease before you install this cover.Note: The cab should be fully lowered and the bolts for the ROPS tightened before you proceed with the following step. Refer to Operation and Maintenance, "Cab Tilting".
Install cover (10). Start by positioning the cover on the machine, as shown. See Illustration 48.Remove the protective paper strip from the tape strip on edge (W) and press the tape strip in position. Repeat this task for the tape strip on edges (X), on edges (Y), and on edge (Z) .Note: Do not remove the protective paper strip from more that one tape strip at a time in order to avoid contamination of the adhesive.Installing the two 312-2613 Cover As
Illustration 49 g01410297
The shape of the 312-2613 Cover As (12)
Illustration 50 g01410572
Pictorial view of the 312-2613 Cover As (12)
Illustration 51 g01410298
Inside view of the right tower that shows the installation of cover (12) (11) 311-6565 Bracket As (12) 312-2513 Cover As
Illustration 52 g01410308
The right tower plate is removed in this illustration for clarity in order to show the installation of cover (24) . (11) 311-6565 BRACKET AS (12) 312-2513 COVER AS Note: Ensure that the mounting surface is clean and free of grease before you install this cover.
Install cover (12) inside the right tower. Install the cover by removing the protective paper strips from the tape strips and by pressing the tape strips in position. See Illustration 51.Note: Follow installation sequence of side (W), side (X), side (Y), and side (Z), as shown. See Illustration 52.Note: Do not remove the protective paper strip from more that one tape strip at a time in order to avoid contamination of the adhesive.
Illustration 53 g01410615
Inside view of the left tower that shows the installation of cover (12) (11) 311-6565 Bracket As (12) 312-2613 Cover As Note: Ensure that the mounting surface is clean and free of grease before you install this cover.
Use the instructions in the previous step and install cover (12) inside the left tower. See Illustration 53.Appendix
Modifying the 310-9335 Seal (24A)
Illustration 54 g01407290
Remove areas that are shown in crosshatch from the "tongue side" of seal (24A). Seal (24A) is installed on the hinge side of the rear door. (A) 10.7 1.0 mm (0.42 0.04 inch) (B) 155 5 mm (6 0.2 inch) (C) 417 5 mm (16 0.2 inch) (D) 111 5 mm (4 0.2 inch) (Z) Tongue side of the sealModifying 310-9335 Seal (24B)
Illustration 55 g01406704
Remove areas that are shown in crosshatch from the tongue side of seal (24B). Seal (24B) is installed on the latch side of the rear door. (A) 10.7 1.0 mm (0.42 0.04 inch) (B) 223 5 mm (9 0.2 inch) (C) 415 5 mm (16 0.2 inch) (D) 80 5 mm (3 0.2 inch) (Z) Tongue side of the sealService Parts
Table 8
5P-7482 Seal (22) (1)
Service Part