TUBE 2214594 - Caterpillar

Lift Eyes Can Fail (12)This safety message is positioned on the top of the hydraulic tank and the fuel tank.
g00100728
LIFT EYES OR TANK CAN FAIL WHEN LIFTING TANK CONTAINING FLUIDS RESULTING IN POSSIBLE PERSONAL INJURY. DRAIN TANK OF ALL FLUIDS BEFORE LIFTING.
Improper Connections for Jump Start Cables (13)This safety message is positioned on the circuit breaker panel in the battery compartment.
g00038786
Improper jumper cable connections may cause an explosion resulting in personal injury. Batteries may be located in separate compartments. When using jumper cables, always connect positive (+) cable to positive (+) terminal of battery connected to starter solenoid and negative (-) cable from external source to starter negative (-) terminal. (If not equipped with starter negative terminal, connect to engine block.) Follow procedure in the Operation and Maintenance Manual.
Pressurized System (14)This safety message is positioned on the radiator.
g00752966
Pressurized system: Hot coolant can cause serious burn. To open cap, stop engine, wait until radiator is cool. Then loosen cap slowly to relieve the pressure.
Machine Swings (15)This safety message is located in two places on the rear of each side of the machine.
g00750340
Machine swings. Stay back. Crushing hazard could cause serious injury or death.
High Pressure Cylinder (16)This safety message is located on the track adjusters.
g00100742
High Pressure Cylinder. Do not remove any parts from the cylinder until all of the pressure has been relieved. This will prevent possible personal injury or death.
Refer to Operation and Maintenance Manual, "Track Adjustment - Adjust" for the proper adjusting procedure.Crush Points (17)This safety message is positioned on the access door to the generator and positioned on the front access door of the left side of the machine. This warning is also located on the front of the machine near the boom foot.
g00104210Stand away from the cab when the cab is being tilted for transportation or repair. there is no clearance for a person in this area. Severe injury or death from crushing could occur.Falling Object Guard Structure (18)This safety message is positioned on the front falling object guard structure.
g00943797
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
Electrical Shock Hazard (19)This warning label is located on the generator control panel. The generator control panel is located inside the cab riser.
g00709188
Before servicing, turn generator disconnect switch to the OFF position. Failure to do so could result in serious injury or death.