TUBE AS 2246371 - Caterpillar

Important Information
When testing must be done in a closed area, activate the brakes and use blocks to prevent the machine from moving during the tests. Let only approved personnel on the machine. Keep other personnel off the machine and in view of the operator.
All tests and adjustments must be made with the oil in the hydraulic control system at normal operating temperature. Be sure the linkage adjustments are correct before making any tests.
HYDRAULIC CONTROLS (FIRST SPEED FORWARD) 1. Body of the selector valve.2. Spool for speed selection.3. Body of the pressure control valve.4. Modulation relief valve.5. Load piston.6. Oil filter.7. Spool for direction selection.8. Ratio valve for converter inlet.9. Combination valve (differential, safety, flow control and check).10. Torque converter.11. Lubrication relief valve.12. Oil cooler.13. Oil pump.14. Magnetic strainer.15. Oil sump.16. Oil line for transmission lubrication.A. Pressure tap, P3, for the inlet to the torque converter.B. Pressure tap, P1, for the speed clutch.C. Pressure tap for the outlet from the torque converter.D. Pressure tap for the pump.E. Pressure tap for lubrication.F. Pressure tap for the pump.G. Pressure tap, P2, for the direction clutch.Location Of The Pressure Taps And Transmission Testing
A. Inlet to the torque converter, P3. B. Speed clutch, P1. D. Pump. G. Direction clutch, P2.
C. Outlet from the torque converter.
E. Lubrication. F. Pump.
EARLIER 1P8975 PRESSURE CONTROL VALVE
LATER 1P8975 AND 3P4489 PRESSURE CONTROL VALVE
3. Body of the pressure control valve. 4. Modulating relief valve. 5. Load piston. 8. Ratio valve for converter inlet. 9. Combination valve (differential, safety, flow control and check). 19. Spacers. Spool Adjustments For The Speed And Direction Valve
Do not make any adjustments to the linkage with the engine running.
SELECTOR VALVE
1. Body of the selector valve. 2. Body of the pressure control valve. 3. Spool for speed selection. 4. Spool for direction selection.1. Make the adjustment to direction spool (4) so the end of the spool is flush with the front face of valve body (1) when the spool and detent are in the REVERSE position.2. Make the adjustment to speed selection spool (3) so the end of the spool is flush with the front face of valve body (1) when the spool and detent are in the FOURTH SPEED position. Tighten nuts on the end of spools (3) and C (4) to a torque of 25 5 lb. ft. (35 0.7 mkg).Linkage Adjustment For The Transmission Hydraulic Controls
Do not make any adjustments to the linkage with the engine running.
LINKAGE FOR THE TRANSMISSION HYDRAULIC CONTROLS
1. Speed and directional control handle. 2. Rack. 3. Cap. 4. Housing. 5. Safety lock lever. 6. Rod. 7. Directional control rod. 8. Directional control lever. 9. Bellcrank. 10. Speed control lever. 11. Speed control rod. A. Reference dimension 5.94 in. (150.88 mm).1. Put safety lock lever (5) in locked position.2. Put directional control lever (8) in NEUTRAL.