TUBE AS 2300510 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     6V-3155     Brace Assembly     1    Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01336896
Attach a suitable lifting device to main control valve (7). The weight of main control valve (7) is approximately 45 kg (100 lb). Position main control valve (7) and install bolts (6) .
Illustration 2 g01336874
Connect all tube assemblies (3). Connect all hose assemblies (4). Connect harness assembly (5) .
Illustration 3 g01290326
Attach Tooling (B) and a suitable lifting device to guard assembly (2). The weight of guard assembly (2) is approximately 68 kg (150 lb). Install guard assembly (2) .
Illustration 4 g01336871
Raise lift arms (1) and remove Tooling (A) .
Fill the hydraulic tank. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change".