TUBE AS 2582983 - Caterpillar

Illustration 30 g00358360
Install two bolts (73) and two nuts in order to hold the housing for the impeller clutch (72) to the backing plate. Attach a hoist and a suitable lifting device to Tooling (D), as shown. Remove impeller clutch (71) from shaft assembly (70) .
Illustration 31 g00999866
Attach a hoist and a suitable lifting device to Tooling (B), as shown. Remove impeller (77) from impeller housing (78) .
Remove thrust bearing (74), sleeve (75) and two pins (76) .
Illustration 32 g00358492
Remove plate (79). If necessary, remove four dowel pins (81) that are located under plate (79). Remove twelve bolts (82), adapter (83) and sleeve bearing (80) .
Illustration 33 g00358612
Remove impeller hub (84) from impeller (85) .
Illustration 34 g00358615
Remove two previously installed bolts (73) .
Attach a hoist and a suitable lifting device to Tooling (B), as shown. Remove backing plate (86) from impeller housing (78) for the impeller clutch.
Illustration 35 g00358617
Remove three discs (87) and two plates.
Illustration 36 g00358619
Remove piston (88) .
Illustration 37 g00358673
Remove two seals (89) .
Illustration 38 g00358678
Remove thrust washer (90). Remove the plate and two dowel pins that are located under thrust washer (90) .
Illustration 39 g00358692
Remove twelve bolts (91) and gears (93). Remove bearing race (92) from gears (93) .
Illustration 40 g00358695
Remove six bolts (95) and two retainer plates (97). Remove freewheel race (94). Remove two seals (96) and three seals (99) .
Drive in locator pin (101) and remove seal carrier (98). Remove bearing (100) from the carrier assembly (102) .
Illustration 41 g00358697
Remove the twelve bolts (not shown) and bearing cage (105) from carrier assembly (102).
Remove lip seal (103), speed sensor (104) and plug (106) .
Remove the O-ring seal from plug (106) .
Illustration 42 g00358698
Attach a hoist and a suitable lifting device to Tooling (E), as shown. Remove shaft assembly (107) from carrier assembly (102). Remove gasket (108) .
Illustration 43 g00358712
Remove two seals (113) and seal carrier (112). Remove bearing (111) from shaft (114). Remove seal (110) and seal carrier (109) .