TUBE AS 2586606 - Caterpillar

Illustration 1 g00847902
Connector Location (1) Connector for Caterpillar Electronic Technician. (2) Connector for Caterpillar Monitoring System
Illustration 2 g00828862
Symbol for the Hour MeterThe "Clear" switch is used in order to step through the program in Caterpillar Monitoring System. The technician should toggle the "Clear" switch as the display for the Caterpillar Monitoring System shows the symbol for the Hour Meter.The numerical code will use as many as six digits. The digits are divided into three fields with two digits in each field. For example, "10_ _01" is the calibration mode for the lift lever sensor. The first two digits would be the calibration submode for the lift lever sensor. The last two digits are for the position in the calibration.Calibration of the Lift Lever Sensor
Move away from other operating machines and away from personnel. Park the machine on a smooth, level surface. Lower the work tool to the ground. Turn the engine start switch to the OFF position.
Connect the 4C-8195 Control Service Tool to the machine.
Turn the engine start switch to the ON position.
Enter the calibration mode. Toggle and hold the "Mode" switch until "-8-" is shown on the display. Release the "Mode" switch when "-8-" is shown on the display. The display will show "_ _81_ _".
Toggle the Scroll switch until "_ _82_ _" is shown on the display.
Enter the Calibration mode. Toggle the "Clear" switch one time. The display should show "82_ _10". Enter the calibration mode for the lift lever position sensor.
Enter the calibration mode for the lift lever position sensor. Toggle the "Clear" switch. The display should show "10_ _01".
Set the parking brake. The display should show "10_ _02".
Activate the implement lockout switch. The display should show "10_ _03".
Verify that the lift lever is in the HOLD position.
Toggle the "Clear" switch. The display should show "10_ _04".
Place the lift lever into the full RAISE position.Note: If equipped, allow the detent to hold the control lever.Note: The electromagnet for the detent will turn on at this point. If the operator is instructed to put the lever in the detent then the lever should be released. The lever will be held by the lift lever electromagnet. If the machine is not equipped with the electromagnets the operator can allow the mechanical detent to hold the lever. For levers with no detent, the operator must hold the lever against the end of travel stop.
Toggle the "Clear" switch. The display should show "10_ _05".
Place the lift control lever into the full LOWER position.Note: If equipped, allow the detent to hold the control lever.
Toggle the "Clear" switch. The control lever should return to the HOLD position. The display should show "10_ _- -". The calibration of the lift lever was successful.Calibration Failure Messages
The numerical code will use as many as six digits. The digits are divided into three fields with two digits in each field. The first two digits of the code "10E002" would be the calibration submode. The last digits of the code "10E002" show that a failure has occurred and