TUBE AS 2846941 - Caterpillar

Illustration 7 g00363677
Install carrier assembly (17) over the end of the pinion shaft. Be sure that the carrier assembly is completely seated. It may be necessary to use a press to seat the carrier assembly.
Illustration 8 g00363674
Note: Spacers (25) and (26) control the amount of rolling torque of the pinion shaft.
Use the following procedure to determine the correct rolling torque of the pinion shaft.
Temporarily install bolt (12). Tighten the bolt to a torque of 315 20 N m (230 15 lb ft).
Use bolt (12) to slowly turn the pinion shaft with a suitable torque wrench. Record the reading as the pinion shaft is being turned. The correct rolling torque of the pinion shaft must be 6.03 2.59 N m (53 23 lb in).
Remove bolt (12), and separate the pinion shaft from the swing drive housing. Change spacers (25) and (26), as required. Change spacers (25) and (26) in order to obtain the correct rolling torque of the pinion shaft.
Reinstall the pinion shaft in the swing drive housing. Apply 9S-3263 Thread Lock Compound on the threads of bolt (12). Install bolt (12). Tighten the bolt to a torque of 315 20 N m (230 15 lb ft).
Install O-ring seal (13) in the swing drive housing.
Illustration 9 g00363676
Install O-ring seal (16) in cage (15). Apply 5P-0960 Molybdenum Grease on the seal.
Illustration 10 g00363675
Apply 1U-8846 Liquid Gasket on the mating surfaces of cage (15) and the swing drive housing.
Put cage (15) in the cage's original position on the swing drive housing. Apply 9S-3263 Thread Lock Compound on the threads of eight bolts (14). Install eight bolts (14) and the washers that hold the cage to the swing drive housing. Tighten the bolts to a torque of 33 3 N m (24 2 lb ft).
Illustration 11 g00363672
Install ring gear (4) on the swing drive housing in the ring gear's original position. It may be necessary to rotate the ring gear back and